ADENDORFF MAC AFRIC SDRILC-024 Orijinal Kullanım Talimatları - Sayfa 9

Döner Çekiç ADENDORFF MAC AFRIC SDRILC-024 için çevrimiçi göz atın veya pdf Orijinal Kullanım Talimatları indirin. ADENDORFF MAC AFRIC SDRILC-024 11 sayfaları. Cordless brushless rotary hammer

Sayfayı Yazdır

Set the operating mode selector to the symbol, and position the bit at the desired location for

the hole, then pull the switch trigger.

Eccentricity in the bit rotation may occur while operating the tool with no load. The tool

automatically centers itself during operation. This does not affect the drilling precision.

2. Chipping/Scaling/Demolition

Set the operating mode selector to the

the tool on and apply slight pressure on the tool so that the tool will not bounce around,

uncontrolled. Pressing very hard onthe tool will not increase the efficiency.

3. Drilling in wood or metal

SDS-plus hammer drill bit and the chuck

adapter can be used when drilling on the

steel, wood or plastic. Screw the drill chuck

in the connecting rod and tighten the lock

screw. Then insert the connecting rod into

the collect in the same way as installing

SDS-plus hammer drill bit. (Fig. 15)

The drill chuck and the chuck adapter are

optional accessories and sold separately.

Continuous Use

If the tool is operated continuously until the battery cartridge has discharged, allow the tool to

rest for 15minutes before proceeding with a fresh battery.

Overload Protection

The motor will stop if it is overload during the operation. Release the switch button then push

it to start the tool again.

Over Temperature Protection

Overload is not allowed during the operation of the tool. The electronic control system will

stop the tool when it is overload or the temperature is over 75℃.

symbol.Hold the tool firmly with both hands. Turn

-16-

Deep Discharging Protection

The tool is equipped with a protective circuit to protect the battery against deep discharging.

When the battery is near to be empty, the protective circuit actuates to switch off the tool.

Disposal of Battery

Lithium ion battery is contained in the battery pack. For environmental protection, recycle or

dispose of the worn out battery properly. Please consult with your local relevant departments

about how to recycle and/or dispose of the worn out battery.

To recycle or dispose of the worn out battery:

a) Remove the battery from the tool when it is worn out.

b) Wrap the terminals with a strong tape to avoid short-circuit and electric leakage.

Never attempt to disassemble or disembowel the battery!

MAINTENANCE AND INSPECTION

CAUTION:

 Always be sure that the tool is switched off and the battery is removed before attempting to

perform inspection or maintenance.

Cleaning Ventilation Slots

For safe and proper working, always keep the power tool and its ventilation slots clean. Use a

soft, clean and dry brush to clean the ventilation slots regularly or when they're clogged.

Inspecting the Mounting Screws

Regularly inspect all mounting screws and ensure that they are properly tightened. Should

any of the screws be loose, retighten them immediately. Failure to do so could result in

serious hazard.

Cleaning

Only use soft and dry cloth to wipe the body of the tool. Do not clean the tool with wet cloth,

thinner, gasoline or other volatile solvents.

-17-