dbx 215 Kullanıcı Kılavuzu - Sayfa 10
Stereo Ekolayzer dbx 215 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. dbx 215 12 sayfaları. 2-series graphic equalizers
Ayrıca dbx 215 için: Şartname Sayfası (2 sayfalar)
Sayfayı Yazdır
- 1. Important Safety Instructions
- 2. Safety Info
- 2. Electromagnetic Compatibility
- 2. Table of Contents
- 3. Service Contact Info
- 4. Warranty
- 5. Introduction and Features
- 6. Operating Controls
- 7. Connecting the EQ to Your System
- 8. Rear Panel Descriptions
- 9. Installation Considerations
- 10. Operation and Applications Notes
- 11. Specifications
User Manual
Insert the graphic equalizer between the signal source (usually a mixer) and the
power amplifiers (or the crossover if there is one). Adjust the level and equalization as
required to yield the desired system response.
For optimum signal-to-noise response, the gain structure of the sound system must be
properly set up. Each component of the sound system should be set at its nominal
operating level, starting with the first element in the system, usually a mixing console.
Each element should be run at its nominal operating level in order to take advantage
of the maximum signal-to-noise properties of that element. Loudspeaker amplifiers, as
the last element in the chain, should be set only as loud as necessary, in order to
avoid inducing unnecessary noise into the system.
S
PECIFICATIONS
Inputs
Connectors:
Type:
Impedance:
Max Input Level:
CMRR:
Outputs
Connectors:
Type:
Impedance:
Max Output Level:
System Performance
Bandwidth:
Frequency Response:
Dynamic Range:
Signal-to-Noise:
THD+Noise:
Interchannel Crosstalk:
Function Switches
EQ Bypass:
Low Cut:
Range:
Power Supply
Operating Voltage:
Power Consumption:
Mains Connection:
Physical Dimensions
231:
215:
131:
Note: Specifications subject to change.
10
1/4" TRS, female XLR (pin 2 hot)
Electronically balanced/unbalanced, RF filtered
Balanced 40kΩ, unbalanced 20kΩ
>+21dBu balanced or unbalanced
>40dB, typically >55dB at 1kHz
1/4" TRS, male XLR (pin 2 hot)
Impedance-balanced/unbalanced, RF filtered
Balanced 100Ω, unbalanced 50Ω
>+21dBu balanced/unbalanced into 2kΩ or greater
>+18dBm balanced/unbalanced (into 600Ω)
20Hz to 20kHz, +0.5/-1dB
<10Hz to >50kHz, +0.5/-3dB
108db
90db
<0.004%
<-80dB, 20Hz to 20kHz
Bypasses the graphic equalizer section in the sig-
nal path
Activates the 50Hz 12dB/octave high-pass filter
Selects either +/- 6dB or +/- 12dB slider boost/cut
range
100VAC 50/60Hz, 120VAC 60Hz, 230VAC 50/60Hz
12W (231=15W)
IEC receptacle
Size: 3.5"Hx19"Wx6"D Weight: 6 lbs
Size: 1.75"Hx19"Wx6"D Weight: 4.7 lbs
Size: 1.75"Hx19"Wx6"D Weight: 4.7 lbs
2-Series