909 BS9 Kullanım Kılavuzu - Sayfa 13

Testere 909 BS9 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. 909 BS9 16 sayfaları. 230mm (9") band saw

Sayfayı Yazdır

Power Indicator light

Located next to the light switch is a small power indicator.

When power is available to the saw assembly this indicator

will glow. The indicator will glow regardless of the Red

and Green push buttons if the 3 pin plug is plugged in and

turned on.

Turning on and off

To turn the saw on, press the

green button marked "I". The

blade will start rotating.

To turn the saw off, press the red

button marked "O". The blade will

stop rotating after a few seconds.

Note.

The switch used on this

saw is an electromagnetic switch,

and in the event of a power failure, the switch must be reset

by pressing the green "on" button when the power resumes

Turning on the flexible light

The Flexible light will illuminate the work area for greater

visibility of the work area and cutting line.

1. To turn the worklight on press

the light on/off switch (3).

2. To turn the worklight off press

the light on/off switch one

more time.

3. Adjust the work light to the

most convenient position for

the task being undertaken.

Removing and installing band saw blades

WARNING.

Always ensure that the saw is switched off and

unplugged from the power supply before making

any adjustments.

This bandsaw is supplied with a general purpose

woodcutting blade.

1. Remove the rip fence from the table.

2. Remove the hex screw, washer and bracket from the

front of the work table by loosening the hex screw using

the 10mm wrench.

3. Open the blade housing doors.

4. Remove the table insert (11)

so you can get better access

to the blade guard. Loosen

and remove the hex screw

that secures the blade guard

in position using the 3mm hex

key supplied. The blade guard

can now be pushed to the side

of the blade.

5. Loosen the blade tension knob

to slacken the blade.