Galaxy DX-55HP Kullanıcı El Kitabı - Sayfa 6

Alıcı-Verici Galaxy DX-55HP için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Galaxy DX-55HP 10 sayfaları. 10-meter am/fm mobile transceiver built in frequency counter with roger beep

Sayfayı Yazdır

1. Control Functions

5. DIMMER (inner dual concentric). Turns on/off the frequency display,

channel number and the meter lamp. Switch on at minimum brightness

and rotate clockwise for brighter illumination.

6. RF POWER (outer dual concentric). This switch is used to select

transmitting power.

7. BAND SELECTOR. This switch selects A, B, C, D, E or F band of

operation.

8. CLARIFIER. Allows variation of the receiver operating frequencies

above and below the assigned frequency. It may be used to optimize

AM/FM signals as described in the Operating Procedure paragraphs,

operates both TX/RX.

9. CHANNEL SELECTOR. This switch selects any one of the forty

channels desired. The selected channel appears on the LED readout

directly above the Channel Selector knob.

10. METER. This meter indicates received signal strength, and transmitter

RF output power.

11. MODE (FM/AM/PA) SWITCH. This switch is used to select PA, FM,

AM mode of operation. The AM or FM mode is normally selected but

when you set to PA position, the transceiver acts as a public address

amplifier. Before operating PA, you must first connect an external PA

speaker (8 ohm, more than 2W) to the PA Speaker jack on the unit rear

panel.

12. F. DISPLAY OFF/NB/OFF SWITCH. When the switch is placed in

the NB position, the RF noise blanker is activated. The RF noise blanker

is very effective for repetitive impulse noise such as ignition

interference. If you wish to turn off the frequency display only set switch

to NB+ position.

13. ROGER BEEP SWITCH. When this switch is placed in the ROGER

BEEP position, your radio automatically transmits the audio sign at the

end of your transmission. The listener can note easily your transmission

is over through the sign.

14. +10KHz FREQUENCY SHIFT SWITCH. When switch is pressed the

frequency is shifted 10KHz up. On following channels. A channel can

be used by setting this switch to +10KHz position.

- 9 -

Normal

15. FREQUENCY COUNTER. This frequency counter LEDS indicate the

selected transmit and receive frequency you are operating on.

16. CHANNEL INDICATOR. The numbered LEDS indicate the selected

channel you are on.

+10KHz

11A

15A

19A

- 10 -