ADENDORFF MAC AFRIC SDRILC-005 Orijinal Kullanım Talimatları - Sayfa 6
Elektrikli Tornavida ADENDORFF MAC AFRIC SDRILC-005 için çevrimiçi göz atın veya pdf Orijinal Kullanım Talimatları indirin. ADENDORFF MAC AFRIC SDRILC-005 14 sayfaları. Cordless brushless driver/hammer drill
Sayfayı Yazdır
INSTRUCTIONS FOR OPERATION
Installing or Removing the Battery
CAUTION:
Use only specified type battery. Other types/brands of batteries may burst cause
personal injury and property damage.
Always switch off the tool and set the reversing switch lever to the center position
before insertion or removal of the battery cartridge.
Do not use force when inserting or removing the battery cartridge. If the cartridge does
not slide in easily, it is not being inserted correctly.
NOTE: The battery is supplied partially charged. To ensure full capacity of the battery,
completely charge the battery in the battery charger before using the tool for the first time.
1. Installing the Battery
To install the battery firmly, insert it properly all the
way until it locks in place with a little click. If not, it
may accidentally fall out of the tool, causing injury to
you or someone around you. Avoid overexerting or
hammering the battery into the motor housing with
the help of other objects. (Fig.2)
2. Removing the Battery
To remove the battery, press the unlocking buttons
on both sides of the battery and pull out the
battery downwards. (Fig.3)
Battery Indicator
CAUTION:
The four charging lights may flash in red color if the
tool is overheated or overloaded. As temperature
recovers or over-load protection is removed, press
the switch and the tool can be started normally.
Current power of the battery will be indicated by the
battery indicator when pressing the battery
button or switching on the tool. (Fig. 4)
Four red LED lights are set to indicate the
battery power which can be referred to the
following table.
Status of Red LED Lights
4 lights lit
3 lights lit
2 lights lit
1 light lit
1 light extinguished after 5 times flash
Battery Charging
1. Battery Charger
Notice:
The charger applies to charge for specified Li-on Battery under normal
circumstances.
Make sure that the AC voltage of the power source meets the requirement specified on
the nameplate of the charger.
Due to the continuing program of research and development, the specifications herein
are subject to change without prior notice.
Approx. Battery Power Left
≥3/4
≥1/2
≥1/4
＜1/4
Low level