909 LS15CS Kullanım Kılavuzu - Sayfa 5
Testere 909 LS15CS için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. 909 LS15CS 16 sayfaları. 15 amp dual laser circular saw with magnesium
Sayfayı Yazdır
3. Do not use tool if switch does not turn it on or off.
Any tool that cannot be controlled with the switch is
dangerous and must be repaired.
4. Disconnect the plug from the power source before
making any adjustments, changing accessories,
or storing the tool.
Such preventive safety measures
reduce the risk of starting the tool accidentally.
5. Store idle tools out of reach of children and other
untrained persons.
Tools are dangerous in the hands of
untrained users.
6. Maintain tools with care.
Keep cutting tools sharp and
clean. Properly maintained tools, with sharp cutting edges
are less likely to bind and are easier to control.
7. Check for misalignment or binding of moving parts,
breakage of parts, and any other condition that may
affect the tools operation.
serviced before using. Many accidents are caused by
poorly maintained tools.
8. Use only accessories that are recommended by the
manufacturer for your model.
suitable for one tool, may become hazardous when used
on another tool or model.
Service
1. Tools service must be performed only by qualified
repair personnel.
Service or maintenance performed by
unqualified personnel could result in a risk of injury.
2. When servicing a tool, use only identical replacement
parts.
Follow instructions in the Maintenance section of
this manual. Use of unauthorized parts or failure to follow
Maintenance Instructions may create a risk of electric
shock or injury.
If damaged, have the tool
Accessories that may be
Safety rules for laser lights
AVERTISSEMENT
CAUTION
RAYONNEMENT LASER – NE PAS REGARDER LE RAYON NI
VISUALISER DIRECTEMENT À L'AIDE D'INSTRUMENTS D'OPTIQUE
LASER RADIATION – DO NOT STARE INTO BEAM
OR VIEW DIRECTLY WITH OPTICAL INSTRUMENTS
Longueur d'onde / Wavelength: 650 nm
Puissance max. / Max Output: 1 mW
Produit laser de classe II / Class II Laser Product
Conforme aux parties 1040.10 et 1040.11
de la norme FDA21 CFR
Complies with FDA21 CFR Parts 1040.10 and 1040.11
É
VITER L'EXPOSITION – Un rayonnement laser passe par cette ouverture
AVOID EXPOSURE – Laser radiation is emitted through this aperture
The laser guide used in the tool is Class II with a maximum
output of 1mW and a wavelength of 650nm. The laser
guide does not normally present an optical hazard, although
staring at the beam may cause flash blindness.
User information
CAUTION.
The use of optical instruments with this laser
product will increase the chance of eye damage.
•
Do not stare into the laser beam.
•
The laser shall be used and maintained in accordance
with the manufacturer's instructions.
•
Never aim the beam at any person or an object other
than the work piece.
•
Always ensure the laser beam is aimed at a sturdy
work piece without a reflective surface (i.e. wood or
rough coated surfaces are acceptable). Bright shiny
reflective sheet or the like is not suitable for laser use
as the reflective surface could direct the beam back at
the operator.
Additional safety rules for circular saws
DANGER!
Keep hands away from cutting area and blade.
Keep your second hand on auxiliary handle, or motor
housing. If both hands are holding the saw, they cannot be
cut by the blade.
•
Keep your body positioned to either side of the saw
blade, but not in line with the saw blade. Kickback could
cause the saw to jump backwards.
•
Do not reach underneath the workpiece. The guard
cannot protect you from the blade below the work.
5