909 P3059 Kullanım Kılavuzu - Sayfa 5
Testere 909 P3059 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. 909 P3059 16 sayfaları.
Sayfayı Yazdır17. Stay alert.
Watch what you are doing. Use common
sense. Do not operate a power tool when you are tired.
18. Check for damaged parts.
that there are no damaged parts. If a part is slightly
damaged, carefully determine if it will operate properly
and perform its intended function. Check for alignment
of moving parts, binding of moving parts, breakage
of parts, proper mounting and any other conditions
that may affect the operation of the tool. A part that is
damaged should be properly repaired or replaced by an
authorised service facility, unless otherwise indicated in
this Instruction Manual.
Defective switches must be replaced by an authorised
service facility. Do not use a tool if the switch does not
turn the tool on and off correctly.
19. Guard against electric shock.
with grounded objects such as water pipes, radiators,
cookers and refrigerator enclosures.
20. Use only approved parts.
identical replacement parts. Use an authorised service
facility to fit replacement parts.
21. This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities,
or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
Additional safety rules for cut off saws
WARNINGS.
Always wear eye protection.
Do not use cutting wheels, the maximum permissible speed
of which is below the RPM value stated on the tool.
•
Check the cut off disc before mounting it into the saw.
Strike the disc with a wooden handle whilst balancing the
disc on your finger. Listen for the ring. If the tone is dull,
do not use the disc. It may be cracked.
Before using a tool, check
Prevent body contact
When servicing, use only
•
When the disc is installed, stand to one side, out of line
with the disc, and run the tool for at least a minute to
make sure that it is not faulty. Always stay out of line of
the disc when using the saw.
•
Do not use a cut off disc marked with a lower RPM
than that of the no load speed shown on the rating plate
of the tool.
•
Check that the mains voltage matches that given on
the rating plate before plugging in the tool.
•
Ensure that the workpiece is held tight in the vise.
•
When cutting through long material, ensure that it is
supported properly by packing up each end to match
the height of the vise.
•
Use only good quality cut off discs as poor quality discs
tend to glaze up which can cause unnecessary load on
the motor and resulting damage.
•
Let the disc do the cutting at a reasonable feed. If too
much pressure is applied the motor will be overloaded
causing the disc to slow resulting in inefficient cutting and
possible damage to the motor.
•
When operating the cut off saw, use safety equipment
including safety goggles or shield, ear protection, dust
mask and protective clothing including safety gloves.
WARNING.
Before connecting a tool to a power source
(mains switch power point receptacle, outlet, etc.) be sure
that the voltage supply is the same as that specified on the
nameplate of the tool. A power source with a voltage greater
than that specified for the tool can result in serious injury to
the user, as well as damage to the tool. If in doubt, do not
plug in the tool. Using a power source with a voltage less
than the nameplate rating is harmful to the motor.
The tool must be used only for its prescribed purpose.
Any use other than those mentioned in this Manual will
be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse. The manufacturer shall
not be liable for any changes made to the tool nor for any
damage resulting from such changes.
5