909 PS26W Kullanım Kılavuzu - Sayfa 7
Testere 909 PS26W için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. 909 PS26W 20 sayfaları. 26cc pole trimming saw
Sayfayı YazdırDo not use the tip section of the chain and bar. Kickback
•
can occur in these conditions.
Keep your eyes not only on the branches you are cutting,
•
also keep an eye on the ground to prevent tripping over
branches that already have fallen.
•
Always wear gloves when handling the pole saw chain.
Danger!
BEWARE oF KICKBACK!
WARNING!
Kickback can lead to dangerous loss of control
of the pole saw and result in serious or fatal injury to the
saw operator or to anyone standing close by. Always be
alert. Rotational kickback and pinch kickback are major
chainsaw operational dangers and the leading cause of
most accidents.
General notes
The pole saw is a rugged, powerful device, but you should
nevertheless note a few words of advice. Always make sure
that there is enough oil in the oil tank.
Before using the pole saw to cut, always check the oil is
being pumped onto the chain. Do not use the saw if the
chain is not oiling. If the chain is not oiling, turn off the
motor and remove and clean the bar mount and bar. Some
light smoking is inevitable and no reason for concern. Lift
off the black plastic cover after every use and clean the
area under it. Also clean the pinhole in the oil container lid
after each use. Keep the groove in the guide bar clean at
all times.
If the unit fails to oil the chain properly it may well be that
the groove is full of saw dust and bark shavings. Remove
the chain and clean out the groove with a suitable tool or
blow it out with compressed air. To keep the unit at top
performance the chain must be sharp.
If you notice that the unit's performance is not as it should
be and the chain does not cut into the wood by itself,
the chain should be sharpened. Either use a saw chain
sharpener or have the chain sharpened by a professional.
Unpacking
Due to modern mass production techniques, it is unlikely
that your 909 Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
Contents of carton
The 909 electric pole saw is supplied with the following
accessories as standard.
•
1 x J Handle Assembly (including mounting screws
x 2 & bracket x 2)
•
1 x Tube Spanner / screw driver combination
2 x Hex Keys
•
1 x 10mm Spanner
•
1 x Shoulder Strap
•
1 x Mixing bottle with 40:1 markings
•
7