Galaxy DX 88HL Kullanıcı El Kitabı - Sayfa 10
Radyo Galaxy DX 88HL için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Galaxy DX 88HL 10 sayfaları. Full channel am/fm/ssb mobile built in frequency counter am/fm 10w-ssb 25w with roger beep
Sayfayı Yazdır
Fig. 5 Microphone plug pin numbers viewed from rear of pin
Be sure that the housing and the knurled ring of Fig. 4 are pushed back
onto the microphone cable before starting to solder. If the washer is not
captive to the pin receptacle body, make sure that it is placed on the
threaded portion of the pin receptacle body before soldering.
If the microphone jack is used to hold the pin receptacle during the
soldering operation, best results are obtained when the connections to
pins 1 and 3 are made first and then the connections to pins 2 and 4.
Use a minimum amount of solder and be careful to prevent excessive
solder accumulation on pins, which could cause a short between the pin
and the microphone plug housing.
6. When all soldering connections to the pins of the microphone plug are
complete, push the knurled ring and the housing forward and screw the
housing onto the threaded portion of the pin receptacle body. Note the
location of the screw clearance hole in the plug housing with respect to
the threaded hole in the pin receptacle body. When the housing is
completely threaded into the pin receptacle body, a final fraction of a
turn either clockwise or counterclockwise may be required to align the
screw hole with the threaded hole in the pin receptacle body. When these
are aligned, the retaining screw is then screwed into the place to secure
the housing to the pin receptacle body.
7. The two cable clamp retainer screws should now be tightened to secure
the housing to the microphone cord. If the cutting directions have been
carefully followed, the cable clamp should secure to the insulating jacket
of the microphone cable.
8. Upon completion of the microphone plug wiring, connect and secure the
microphone plug in the transceiver.
receptacle.
- 17 -
WARRANTY
This radio is covered by a two
year limited parts and labor
warranty.
•
"Limited" means that we will repair problems caused by factory defects
or normal use at no charge.
•
Before returning a radio to us for warranty service, please call our
Service Department for a Repair Authorization Number (RAN). This
RAN must be written below your return address on the outside of the
shipping box. Boxes, which arrive without a RAN, will be refused, and
the shipping company will return the unopened box to you. Be sure to
have a pen and paper ready along with the serial number of your radio
before calling. We will give you the RAN and our shipping address over
the phone. The telephone number of the Service Department is (760)
480-8800, and we suggest calling between 10:00 AM and 4:00 PM
Pacific Time.
•
Please include a note with a detailed description of the symptoms. This
is important because it will help the technician who works on your radio
to locate your problem. Intermittent problems are easily overlooked, so
be sure to give as much detail as possible in your note. Also, please
include your telephone number in case our technicians have any
additional questions.
•
Do not send your power cord or microphone unless we ask for these
items during our telephone conversation.
•
You are responsible for getting the radio safely to us. (We suggest using
United Parcel Service.) You must pay to ship the radio to us, and we will
pay to ship the radio back to you. Since we use UPS and they do not ship
to Post Offices boxes, please provide us with a street address for the
return of your radio.
•
We will repair and return your radio as soon as we can. We appreciate
your choosing a Galaxy radio and we want you to be on the air as much
as possible!
Be sure to visit our web site at
www.GalaxyRadios.com
- 18 -