Agrizap Rat Zapper Ürün ve Güvenlik Kılavuzu

Böcek Kontrol Ekipmanları Agrizap Rat Zapper için çevrimiçi göz atın veya pdf Ürün ve Güvenlik Kılavuzu indirin. Agrizap Rat Zapper 10 sayfaları.
Ayrıca Agrizap Rat Zapper için: Hızlı Başlangıç Kılavuzu (2 sayfalar)

Sayfayı Yazdır

Please follow these important steps to ensure you get the maximum benefit from the Rat Zapper

you have purchased (turn the page for pictures of items):

1. Batteries - Install the C-cell batteries and rotate them (see picture of Battery Holder). This

will ensure the batteries are touching the metal contacts on the ends of the battery holder.

Also, ensure the 9 volt battery is installed in the back of the zapper. All batteries should be

new, alkaline batteries.

2. Check Button and Light - These are NOT intended to test the zapper. These DO tell you

whether there is a rodent in the trap.

3. Testing the Rat Zapper - WARNING - this step is purely optional - use caution - please

read all warning labels on product

• place yellow Power Supply and metal Electrocution Chamber on the edge of a bench

or table

• turn the zapper Main Switch ON

• touch the metal tip of a plastic-handled screwdriver against the inside top of the

Chamber and slide it in until the tip touches the Kill Plate (see See-thru View of the

Chamber)

• to trigger the zapper, you must maintain contact between the inside of the Chamber

and the kill plate

• the zapper alarm should sound and you should see a spark between the screwdriver

and the Kill Plate

• to reset the zapper, turn the Main Switch OFF and then back ON

4. Runway Placement - Place the Electrocution Chamber on a flat, level surface against a wall

in an area where there is suspected rodent activity. Remove other traps and sources of food.

5. Pre-baiting Strategy - Rats are intelligent and wary. Therefore, we recommend that you pre-

bait your zapper.

• drop some dry bait through the bait hole into the Bait Dish in the Chamber (see

Breakaway View of Electrocution Chamber), but leave the Main Switch OFF

• place some bait out in front and in back of the Chamber

• when the bait has been taken from inside the Chamber, re-bait and turn the Main

Switch ON

After zapping your first rodent, the others will be more interested in the zapper. Dispose of the

rodent, then reset the zapper by turning the Main Switch OFF and then back ON. If the bait is

not being taken, try a different bait or try moving the trap or call Agrizap, Inc. for more

suggestions.

For more details, please read the attached Product and Safety Manual. We believe you will find

our Rat Zappers to be the most effective way to deal with an unpleasant problem. Let us know

how it works for you by calling us at (888) DEAD-RAT (332-3728). Thanks.

Quick Start

Updated August 7, 1998