909 T12 Series Manuel - Sayfa 4

Matkap 909 T12 Series için çevrimiçi göz atın veya pdf Manuel indirin. 909 T12 Series 17 sayfaları.

Sayfayı Yazdır

Touch Sensor Grip Power Tool

Congratulations on purchasing a Touch Sensor Grip (TSG) Power

tool. The TSG system incorporates a fully electronic control system

which operates the tool on pressure applied to the Touch area,

instantaneously allowing operation between Forward and reverse.

Tools fitted with TSG are truly a left and right handed tool, easy to

operate and is the latest technology in Power Tool development

Touch Sensor Grip (TSG)

CAUTION!

Your 12V 909

drill driver is equipped with the

innovative TSG System. It is

important to read and understand

the following instructions to get

the best use of the TSG system.

(fig. D)

ACTIVATE THE TOOL

• Fit the tool with a fully charged battery pack by following the section

Fitting and removing the battery pack to the drill on page 3.

• Hold the tool naturally, with your index finger on the Forward Touch

Pad and the middle finger on the Reverse Touch pad.

• Firmly press the Forward and Reverse Touch Pad at the same time

to activate the tool. Both LED work light

and Power Consumption LED will light up

to indicate a successful activation.

• Release the fingers from Forward and

Reverse Pad. The tool is awakened from

the sleep mode and ready for use.

SLEEP MODE

• To avoid accidental start, the tool will automatically enter sleep

mode if the user does not operate the tool within any 5 min interval

• In the case where the tool has not been used for the 5 min period,

the tool needs to be re activated to allow the remaining functions

of the drill to be used. To activate the tool, please follow the section

above, Activate the tool.

Touch_IM_ED8.indd 4

(fig. E)

FORWARD AND REVERSE

CAUTION!

To prevent damage to the gears, always

allow the chuck to come to a complete stop before

changing the direction of rotation.

• The unique TSG System allows quick and single handed change

between forward and reverse. For forward mode, simply apply

pressure the Forward Touch Pad area. To switch to reverse mode,

simply release you finger from Forward

Touch Pad and pressure the Reverse

(fig. F)

Touch Pad area instead.

• Drilling uses the forward mode. The

reverse mode is intended for the removal

of screws and assisting to remove jammed

drill bits.

VARIABLE SPEED

CAUTION:

The variable speed control function is NOT

intended to be used for long periods of time during the

operation of the task being performed. Use the variable

speed to start drilling and screwing tasks, and then fully

press the switch once the task has started.

• The TSG system enables the user to adjust the speed of the drill

effortlessly. The speed varies according to the amount of pressure

is applied on the Touch pad area in either forward or reverse. The

higher the pressure applied, the higher speed of the drill.

• To stop the drill, release the finger from the Forward or Reverse

Touch Pad area and allow the chuck to come to a complete stop.

The electric brake quickly stops the chuck from rotating. This

feature engages automatically when fingers are released from TSG

system in either forward or reverse

NOTE:

For speed control, there is no need to squeeze hard on the

Touch Pad. The innovative technology can detect small changes of

pressure applied and adjust the speed accordingly.

NOTE:

This drill is equipped with an electric brake. When the brake

is functioning properly, sparks may be visible through the vent slots

in the housing. This is normal and is the action of the brake.

First time users to familiarise themselves with the sensitivity of the

TSG should squeeze the Touch area and experience the functions

before fitting a drill or driver bit.

22/10/13 4:39:54 PM