dbx Compression 101 Manuel - Sayfa 6

Bilgisayar Donanımı dbx Compression 101 için çevrimiçi göz atın veya pdf Manuel indirin. dbx Compression 101 8 sayfaları. Signal processors

Compression 101

Drums

Engineers often compress drum tracks just to get a nice punchy sound in the mix. the

settings below sound good on a rock snare drum:

Threshold set so that all drum hits are compressed (around -3dB)

Ratio set for 4:1

OverEasy® engaged

Attack set around 8 o'clock

Release set around 9 o'clock

By turning the threshold down even more, you can "squash" the snare drum as

much as you want. Turn the attack up (longer) to get more stick out of the snare

drum, and turn it down for a synth pop slap.

Bass

Since bass guitar forms the foundation of most Rock and Jazz music, it's important that the

level of the Bass doesn't jump around in the mix. Also, adding compression to bass tracks

(or almost anything else) can make it "punchier," generally a good thing in rock tunes. Try

the settings below on a rock bass track:

Threshold set so only the peaks are compressed (around 0dB)

Ratio set for 4:1

Hardknee engaged

Attack set around 9 o'clock

Release set around 10 o'clock

Electric Guitar

Funky rhythm guitar parts love compression. Not only does it make the part punch out the

mix better, it evens out the volume of the muted strums.The following setting, with its low

threshold and high ratio, gives you lots of compression for punching up a funky rhythm

guitar part:

Threshold set for constant compression (around -3dB)

Ratio set for 6:1

OverEasy® engaged

Experiment with turning the Threshold up or down for a thinner or chunkier

tone.

De-Essing

Occasionally when recording vocals, the letter "s" seems to jump out louder than the rest of

the part. This is because sibilant letters, especially the letter s, have more high frequency

energy than other letters. This can cause tape recorders or other components to distort,

even though the level may not seem very loud.

Moving the microphone can sometimes eliminate this "sibilance," but often a de-esser is

required.

Many compressors allow you to perform de-essing on a track by using a sidechain. By

placing an equalizer in the sidechain, you can set the compressor so that only certain

frequency ranges trigger the unit to start compressing.

Compression 101 - November 1998

Page 5