dbx 262 Kullanım Kılavuzu - Sayfa 13

Müzik Ekipmanları dbx 262 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. dbx 262 16 sayfaları. Dbx compressor/ limiter model 262 operation manual

Applications
aging drivers in a sound-reinforcement system (whether you're doing auditori-
um, church, or club sound engineering, or are a mobile DJ for small dances, or
like to push the limits of your home's audio entertainment center). Set the 262
for limiting (Hard Knee mode On, with a COMPRESSION RATIO of 10:1 or
greater) and adjust the THRESHOLD to provide 15dB or more of compression
(just a few dB below the input clip). For low-level signals, the 262 won't
change gain, but if large signals come along, the gain will be reduced to pre-
vent clipping and save sensitive system components from excessive heat
buildup or other type of damage.
In circumstances where the 262 is expected to cause no change in gain unless
an emergency arises (wildly excessive levels), some operators set Hard Knee
mode On, the COMPRESSION RATIO to °:1, and the THRESHOLD to the high-
est permissible level.
As a general rule, compressors should be as close to the amplifiers as possible
in the signal chain. If the 262 is placed before the EQ (equalizer), for example,
a potentially damaging boost in the EQ won't be seen by the 262 and the
speakers may be damaged. For maximum sound pressure levels, large sound
reinforcement systems frequently use a separate compressor on each output of
the electronic crossover(s).
Raising Average Level in PA Systems
Limiting (i.e., compression at high ratios like °:1) also benefits intelligibility by
allowing low-level input signals to be reproduced through the system at higher
volume. In a musical performance, this provides additional intimacy as the
vocalist's whispers are heard clearly at every seat in the house. The OverEasy®
curve available with the 262 permits a very high amount of compression (COM-
PRESSION RATIO of 10:1 or greater) to be used in many situations. This allows
dynamic speakers, vocalists and other musicians to concentrate on their presen-
tation or performance without worrying about the ill effects of volume changes.
Using Your EQ to Reduce Feedback in Live Settings (Indoor and Outdoor
Concerts, Churches)
You can use your 262 and EQ (equalizer) to reduce feedback in clubs, church-
es, outdoor concerts and other live settings. Patch or insert the 262 into the
main output of a mixer, set the 262 to Hard Knee mode and slowly increase the
console gain control until the first feedback "ring" occurs, then set up the 262
with its COMPRESSION RATIO at °:1 and THRESHOLD low. The 262 will catch
the first feedback ring and hold it as a constant tone so you can adjust your EQ
to minimize it. Continue to increase your console gain and set your EQ until the
next 3 or 4 "ring" frequencies have been compensated for.
The 262 as a Line Amplifier
To use the 262 as a line amplifier, adjust the COMPRESSION RATIO control fully
counterclockwise (1:1 position), THRESHOLD fully clockwise (+20) and OUT-
PUT GAIN to whatever setting is required for the application. Remember, exces-
sive gain may lead to output clipping of high level signals. To add compression,
adjust the COMPRESSION RATIO and the THRESHOLD controls to the desired
settings.
Increasing Sustain
To increase the sustain of a musical instrument (e.g., a guitar or bass). Set the
Compressor/
11
Limiter
262