DYNAPAR NorthStar RIM Tach 1250 Kullanım Kılavuzu - Sayfa 7

Ölçüm Cihazları DYNAPAR NorthStar RIM Tach 1250 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. DYNAPAR NorthStar RIM Tach 1250 14 sayfaları. Digital tachometer

Sayfayı Yazdır

2.0 Inspection and Unpacking

Inspect shipping container for external damage. All claims for damage (apparent or concealed) or partial loss of shipment

must be made in writing to Dynapar within (5) days from receipt of goods. If damage or loss is apparent, please notify the

shipping agent immediately.

Open shipping container and locate the packing list. The packing list is included to verify that all components, accessories,

and manual were received. Please use the packing list to check off each item as the unit is unpacked. Inspect for damage.

We recommend that the shipping container be retained for future shipping, storage, or return to factory purposes.

Dynapar cannot be responsible for any missing parts unless notified within 60 days of shipment.

2.1 Painting considerations

The enclosure may be painted. Please pay attention to the following considerations.

Corrosion preventative grease has been applied to the enclosure. Standard degreasing practices

must be followed before applying paint.

• Do not hinder the latches on the connector if the connector is painted.

• If the enclosure is painted before the sensor module(s) is added, be sure to mask off the area where the sensor module(s)

will be placed. The module must mate directly to the enclosure with nothing between. Failure to do this will degrade the

alignment of the system and may cause it to fail.

• Ensure excess paint runoff does not clog Enclosure drain holes.

2.2 Mechanical Installation

Figure 3a: Large Thru-Shaft 1250

NorthStar RIM Tach

1250 Instruction Manual

CHAPTER 2

INSTALLATION

Dynapar (847) 662-2666

The RIM Tach 1250 utilizes a modular

construction, allowing the user to configure

the unit as a one or two signal output

tachometers. Sensor modules are universal

and interchangeable. If one output requires

replacement, simply remove four screws,

and replace with a new sensor module. No

electrical

adjustment

required. Also, you never have to remove

the RIM Tach 1250 enclosure from the

motor. Other devices such as brakes or gear

reducers mounted from the RIM Tach 1250

do not need to be removed. After unpacking

the unit and verifying receipt of the items

listed on the packing list, you may proceed

with mechanical installation.

17 November 2008

alignment