Galaxy Audio HOT SPOT Kullanıcı Kılavuzu - Sayfa 12
Konuşmacılar Galaxy Audio HOT SPOT için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Galaxy Audio HOT SPOT 20 sayfaları. Powered micro spot
Ayrıca Galaxy Audio HOT SPOT için: Kullanıcı El Kitabı (12 sayfalar)
Sayfayı Yazdır
- 1. Table of Contents
- 2. Welcome
- 3. Before You Begin
- 4. Ohm's Law and the Hot Spot
- 5. Sound Reinforcement Basics
- 6. Hot Spot Series/Micro Spot VC
- 7. Powered Hot Spot (Pa5X140)
- 8. Using the Pa5X140
- 9. Rear Panel
- 10. Using the Hot Spot with the Pa5X140
- 11. Stand Mounting
- 12. Mounting Your Micro Spot Series Speakers
- 13. Specifications
- 14. Warranty
- 15. Registration
USING THE HOT SPOT WITH THE PA5X140
POWERED MONITOR
The PA5X140's SPEAKER OUTPUT jack is designed to allow a
maximum of two HOT SPOTS to be "daisy-chained" to it.
The PA5X140 produces 146 watts when powering two HOT
SPOTS (see figure below)
Route cables:
1) From the microphone to Galaxy Audio's PA5X140.
2) From the output of the PA5X140 to the first HOT SPOT.
3) From the first HOT SPOT to the second HOT SPOT.
1
STAND MOUNTING
All HOT SPOT's, both powered and un-powered, have a built in
microphone stand mount: just slide the microphone stand into the
receptacle on the bottom of the HOT SPOT. Some microphone
stands may require an adaptor (contact any Galaxy Audio dealer
and ask for an SA-1, microphone stand adaptor).
THE SA-1 WILL ALLOW YOU TO SECURELY PLACE
YOUR HOT SPOT ON ANY MICROPHONE STAND.
No SA-
Atlas and SHURE
allow HOT SPOT to sit
deep enough on the stand
Stands that don't
need SA-1's
SHURE™
Page 10
needed
1
stands
Atlas™
2
Permanent piece and the collar will
not allow HOT SPOT to sit deep enough
Stands that need SA-1's
K&M™ series stands
Sennheiser™
3
SA-
1
SA-
needed
1
AKG™
Beyer™
Ultimate™