DC DC1300 Kullanım ve Bakım Talimatları
Bulaşık Makinesi DC DC1300 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Talimatları indirin. DC DC1300 2 sayfaları.
Sayfayı YazdırOPERATING AND MAINTENANCE INSTRUCTIONS
POWER
CYCLE
SWITCH
LAMP
PREPARATION
•
CHECK DRAIN PLUG IS PUSHED FIRMLY IN PLACE AND FILTER AND SURFACE FILTER ARE CORRECTLY POSITIONED.
•
CHECK DETERGENT ( RED ) AND RINSE AID ( CLEAR ) SUPPLY TUBES, WITH FOOT VALVES - ARE
SUBMERGED IN SUFFICIENT PRODUCT.
•
CHECK THE HOOD IS CLOSED DOWN AND PRESS THE POWER SWITCH - THE POWER GREEN LAMP WILL COME ON.
•
ALLOW 35 MINUTES FOR THE MACHINE TO REACH THE CORRECT WASHING TEMPERATURE.
OPERATION
•
REMOVE ALL DEBRIS FROM THE ITEMS TO BE WASHED, BEFORE PLACING THEM INTO THE BASKET.
•
SELECT THE WASHING CYCLE TIME SWITCH - 1` 2` OR 3` MINUTE.
•
CLOSE DOWN THE HOOD, THE WASHING CYCLE WILL START AUTOMATICALLY AND THE CYCLE LAMP WILL COME ON.
•
AT THE END OF THE CYCLE THE CYCLE LAMP WILL GO OUT.
•
ALLOW A FEW SECONDS FOR THE WATER TO RETURN TO THE WASH TANK BEFORE LIFTING UP THE HOOD.
•
SLIDE OUT THE BASKET AND ALLOW EXCESS WATER TO RUN OFF BEFORE REMOVING.
ROUTINE MAINTENANCE
•
AT THE END OF A SESSION TURN OFF THE POWER SWITCH, COLLECT THE DEBRIS INTO THE FILTER BOX AND REMOVE.
•
REMOVE THE SURFACE FILTER AND CLEAN THOROUGHLY.
•
DO NOT ALLOW DEBRIS TO GO DOWN INTO THE LOWER WASH TANK.
•
REMOVE THE DRAIN PLUG - THE WASH TANK WILL EMPTY.
•
IF YOUR MACHINE IS FITTED WITH A WASTE PUMP - TURN OFF THE POWER SWITCH AND REMOVE THE
DRAIN PLUG - THEN PRESS AND HOLD THE WASTE PUMP SWITCH UNTIL THE WASH TANK IS EMPTY.
•
DO NOT REMOVE LOWER WASH TANK FILTER OR ( IF FITTED WASTE PUMP FILTER BOX - OPTIONAL ) AT THIS STAGE.
•
CLEAN AROUND THE LOWER WASH TANK AND INSIDE THE HOOD WITH AN 'ADDIS'' TYPE WASHING UP BRUSH.
•
DO NOT ALLOW DEBRIS TO GO DOWN THE OUTLET HOLE AS THIS MAY DAMAGE YOUR MACHINE.
•
THOROUGHLY CLEAN AND REPLACE THE LOWER WASH TANK FILTER - REPLACE THE SURFACE FILTER & FILTER BOX.
•
REGULARLY CHECK RINSE JETS AND WASH JETS ARE CLEAR OF DEBRIS OR LIME SCALE - REMOVE IF NECESSARY BY
UNSCREWING THE RINSE ARM NUT - REMOVE WASH ARM CLEANING CAPS - CLEAN THOROUGHLY AND REASSEMBLE.
•
YOUR WATER SOFTENER ( IF FITTED ) SHOULD BE REGENERATED ONCE A WEEK OR ACCORDING TO INSTRUCTIONS.
RINSE ARM NUT
RINSE JETS
CLEANING CAP
SERVICE CALLS TO RECTIFY FAULTS CAUSED BY `THE LACK OF ROUTINE MAINTENANCE` WILL BE CHARGED FOR
SERVICE TEL.
CYCLE TIME SWITCH
1` 2` OR 3` MINUTE
WASTE PUMP SWITCH
FOOT VALVES
WASH JETS
AND YOUR WARRANTY MAY BE AFFECTED
DC1300
(OPTIONAL)
WASH TANK
TEMPERATURE DISPLAY
LOWER WASH TANK FILTER
BOILER
TEMPERATURE DISPLAY
FILTER BOX
SURFACE FILTER
DRAIN PLUG
(OPTIONAL)
WASTE PUMP
FILTER BOX
directcateringproducts.co.uk
OUTLET HOLE