DC SXD45 Kullanım ve Bakım Talimatları

Bulaşık Makinesi DC SXD45 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Talimatları indirin. DC SXD45 2 sayfaları.
Ayrıca DC SXD45 için: Kullanıcı Kılavuzu (2 sayfalar)

DC SXD45 Kullanım ve Bakım Talimatları
OPERATING AND MAINTENANCE INSTRUCTIONS
POWER LAMP
(OPTIONAL)
DRAIN PUMP
REMOVE DRAIN
PLUG AND SWITCH
THE MACHINE OFF
TO START THE
AUTOMATIC DRAIN
PUMP CYCLE
POWER
SWITCH
PREPARATION

CHECK THE DRAIN PLUG IS PUSHED FIRMLY IN PLACE AND THE FILTER BOWL IS POSITIONED INTO THE OUTLET HOLE.

CHECK THE DETERGENT ( RED ) AND RINSE AID ( CLEAR ) SUPPLY TUBES - WITH FOOT VALVES - ARE SUBMERGED IN SUFFICIENT PRODUCT.

CHECK THE DOOR IS CLOSED AND PRESS THE POWER SWITCH - THE POWER LAMP WILL COME ON.

ALLOW 30 mins FOR THE MACHINE TO FILL WITH WATER AND REACH THE CORRECT WASHING TEMPERATURE.THE MACHINE READY LAMP WILL COME ON.
OPERATION

REMOVE ALL DEBRIS FROM THE ITEMS TO BE WASHED, BEFORE PLACING THEM INTO THE BASKET. SELECT THE CYCLE TIME ,2 MINUTE OR 3 MINUTE.

CLOSE THE DOOR - PRESS THE CYCLE START SWITCH - THE CYCLE LAMP WILL COME ON.

AT THE END OF THE CYCLE THE CYCLE LAMP WILL GO OUT - OPEN THE DOOR AND PULL OUT THE BASKET.

ALLOW EXCESS WATER TO RUN OFF BEFORE REMOVING.
ROUTINE MAINTENANCE

AT THE END OF A SESSION TURN OFF THE POWER SWITCH. DO NOT REMOVE THE FILTER BOWL AT THIS STAGE.

REMOVE THE DRAIN PLUG - THE WASH TANK WILL EMPTY. MACHINES FITTED WITH DRAIN PUMP WILL AUTOMATICALLY START TO PUMP THE WATER OUT.

COLLECT THE DEBRIS AND REMOVE FROM THE WASH TANK.

CLEAN AROUND THE WASH TANK - DOOR SURROUNDS AND HINGES WITH AN 'ADDIS'' TYPE WASHING UP BRUSH.

DO NOT USE CHLORIDE CONTAINING BASED CLEANING SOLUTIONS OR ABRASIVES WHEN CLEANING THE WASH TANK.

TAKE OUT THE FILTER BOWL - CLEAN THOROUGHLY AND REPLACE.

DO NOT ALLOW DEBRIS TO GO DOWN THE OUTLET HOLE AS THIS MAY DAMAGE YOUR MACHINE.

REGULARLY CHECK RINSE JETS AND WASH JETS ARE CLEAR OF DEBRIS OR LIME SCALE - REMOVE IF NECESSARY BY UNSCREWING THE RINSE ARM NUT
THAT HOLDS THE RINSE ARM IN PLACE - REMOVE THE RINSE PIN THAT HOLDS THE WASH ARM IN PLACE - CLEAN BOTH THOROUGHLY AND REASSEMBLE.
WATER SOFTENER

REMEMBER TO REGENERATE THE EXTERNAL WATER SOFTENER IF FITTED REGULARLY. ENSURE THAT THE WATER VALVES ARE TURNED BACK ON
TO SUPPLY THE MACHINE WITH FULL MAINS PRESSURE SOFTENED WATER.
RINSE ARM NUT
RINSE JETS
RINSE PIN
SERVICE CALLS TO RECTIFY FAULTS CAUSED BY `THE LACK OF ROUTINE MAINTENANCE` WILL BE CHARGED FOR
SXD45 / SXD50
CYCLE LAMP
CYCLE START
SWITCH
RINSE ARM
WASH
WASH JETS
AND YOUR WARRANTY MAY BE AFFECTED
www.directcatering.co.uk
FOOT VALVES FOR
CHEMICAL
CONTAINER TUBES
OUTLET HOLE
CYCLE
SELECTION
LAMP
CYCLE TIME
SWITCH
2 MINUTE ~ 3MINUTE
FILTER
BOWL
MACHINE
READY
LAMP
DRAIN PLUG