DynaQuip WaterCop WPSC Kullanım Kılavuzu ve Kurulum Kılavuzu - Sayfa 5

Kontrol Sistemleri DynaQuip WaterCop WPSC için çevrimiçi göz atın veya pdf Kullanım Kılavuzu ve Kurulum Kılavuzu indirin. DynaQuip WaterCop WPSC 16 sayfaları.

Sayfayı Yazdır

DynaQuip WaterCop WPSC Kullanım Kılavuzu ve Kurulum Kılavuzu

into direct contact with a leak sensor's probe, an RF signal is transmitted to the Water Control

Panel and the valve closes, turning off the water source to protect the building from additional

water damage . The red indicator light will signal that the valve is now in the closed position . The

valve will remain closed until the unit is manually reset (through the manual override handle or

the OPEN button on the Water Control Panel) . After the plumbing problem is fixed, reset the

WaterCop® Pro by pressing the OPEN (green circle) on the face of the Water Control Panel .

NOTE: If major repairs are needed to correct the plumbing system, it is recommended that

the main shut-off valve upstream of the Actuator also be closed during the repairs . Close the

main water shut-off valve and unplug the Water Control Panel before making repairs on the

plumbing system .

In case of a power failure, use the manual shut-off valve to turn the water off in case of an

emergency . If enabled by the end user, the WaterCop® Pro Actuator will close the valve for Safe

Mode and will display "POWER RESTORED SAFE MODE CLOSED" on the Water Control Panel

once power is restored after any outage .

Enable/Disable "Safe Mode" Feature

TO ENABLE SAFE MODE:

1 . With the valve in the CLOSED position, press and hold down the MODE button . The display

will read:

2 . While holding down the MODE button, press the OPEN button, then release both

simultaneously . The Safe Mode feature will be enabled .

To verify that SAFE MODE is enabled, press & hold the MODE button . The display will read:

Release the MODE button . Then Press the OPEN button to return to WATERCOP NORMAL .

To Disable the Safe Mode feature, start with the valve in the closed position as noted above,

hold the MODE button & simply press CLOSE button instead and release . When Safe Mode

is disabled and power is restored, WaterCop will return to its last known position (Opened or

Closed) before power was lost .

WaterCop® Pro Specifications

Max . working pressure

Ambient temperature

Enclosure

Voltagex

Current

Valve

Valve seals

SAFE MODE = OFF

OPEN = ON CLOSE = OFF

SAFE MODE = ON

OPEN = ON CLOSE = OFF

125 psig

35° to 105° F

Polycarbonate NEMA 4

12 VDC plus 120 VAC adapter

0 . 8 5 Amps

Full-Port, Lead-Free, Brass, NPT

RTFE (Reinforced Teflon®)

Flow Data

Valve Size Cv = Gpm flow at

1 psi pressure drop

½" NPT

¾" NPT

1" NPT

1 ¼" NPT

For cold water applications