Autonics LE4SA Manuel - Sayfa 10
Zamanlayıcı Autonics LE4SA için çevrimiçi göz atın veya pdf Manuel indirin. Autonics LE4SA 17 sayfaları. Din w48xh48mm digital backlight lcd timer
Ayrıca Autonics LE4SA için: Talimatlar (18 sayfalar)
Sayfayı Yazdır
LE4S Series
● Backlight ON/OFF setting
[Figure6]
※ Factory default
● Key Lock setting
[Figure7]
※ Factory default
Setting Time Change
Please set operation time according to following instruction as the setting is different depending on the output operation
mode.
● Output operation mode: OND, OND Ⅰ , OND Ⅱ , INT, INT Ⅰ , OFF D
(LE4SA does not have no OND Ⅰ , INT Ⅰ , OFF D.)
[Figure1]
1) Press
in RUN mode, time set digits will flash. [Figure 1]
2) Change setting time by using
-
: Shift the setting digits.
-
: Shift the flashing position value. As press
number will increase faster by press
3) When the setting is completed, it will be stored and return to RUN mode by pressing
N-32
1) In function setting mode, if it enters into Backlight ON/OFF setting mode, the characters
will be displayed as shown in the [Figure 6].
2) Select Backlight ON or OFF using
3) Press
to complete Backlight ON/OFF setting and move to the next mode.
4) If pressing
for 3 sec in any function setting mode, it will return to Run mode.
1) In function setting mode, if it enters into Key Lock setting mode, the characters will be
displayed as shown in the [Figure 7].
2) Select
,
,
lOFF
LOc1
LOc2
Blank
Turns off
the Lock mode.
3) Press
to complete key lock setting and move to the next mode.
4) If pressing
for 3 sec in any function setting mode, it will return to Run mode.
※ Factory default for LE4S is
※ Key Lock function
Display
Function
Turns off the key Lock mode.
lOFF
LOc1
LOc2
LOc3
[Figure2]
or
. [Figure 2,3,4]
once, it will increase by 1digit,
for over 2 sec
,
.
or
using
,
LOc3
cannot be used.
cannot be used.
and Factory default for LE4SA is
lOFF
cannot be used.
,
cannot be used.
,
,
cannot be used.
[Figure3]
.
,
,
cannot be used.
.
LOc1
[Figure4]
[Figure5]
[Figure 5]
,