DynaQuip Controls WaterCop classic Kullanım Kılavuzu ve Kurulum Kılavuzu - Sayfa 12

Kontrolör DynaQuip Controls WaterCop classic için çevrimiçi göz atın veya pdf Kullanım Kılavuzu ve Kurulum Kılavuzu indirin. DynaQuip Controls WaterCop classic 12 sayfaları.

Sayfayı Yazdır

4 . Some WaterCop

dip switch units, set switches 1-6 exactly the same on both units . Switches 7 and 8 must

remain in the "on" or "up" position .

5 . Reinstall cover . Carefully tuck wires completely into case and hold cover in position while

tightening screws .

6 . Reconnect power by plugging the power cord into power receptacle .

Changing the Transmitter Code

1 . Remove transmitter cover .

2 . Locate code switch block . Switches are numbered 1 through 8 .

3 . Arrange the switches in the exact combination as the code that you set in the receiver . It is important that the same exact

code be set in the receiver and all transmitters . If the codes differ, the unit will not function properly .

4 . Some WaterCop

1-6 exactly the same on both units . Switches 7 and 8 must remain in the "on" or "up" position .

5 . Test each transmitter to ensure that the unit is functioning properly .

6 . If not, verify that all codes are set the same . When all transmitters are functioning properly, your WaterCop

System is on duty to help protect your home from damage due to plumbing leaks .

WaterCop

Interface Connections

Contacts 5, 6 and 7 are used to control the valve position from a remote location . The most common is your home security

system control panel .

This is done by wiring these contacts to a control switch on the panel . The diagram below shows typical installation options .

This control can be a relay, push buttons or toggle type switch . This control needs to be a momentary switch, which means

that the control switch stays made or "on" for a short period of time (1 to 3 seconds) and then returns to a neutral position .

Contacts 2, 3 and 4 are used to signal a remote

device as to the position of the valve . This is done

by connecting a low voltage circuit with indicator

lights to these contacts . The diagram shows a typical

installation .

When the valve is in the closed position, contacts 2

and 3 will be made completing the circuit and lighting

the indicator light, showing that the valve is in the

normal open position .

When the valve is in the open position, contacts 3

and 4 will be made completing the circuit and lighting

the indicator light, showing that the valve is closed .

Emergency Procedures

In the unlikely event that the WaterCop

due to a power outage or damage, it is possible to manually operate the WaterCop

WaterCop

from its power source . The valve may be manually opened by removing the clip holding the housing to the valve,

sliding the housing off the valve shaft, and turning the valve shaft a quarter turn with a screwdriver .

This procedure should only be necessary in emergencies .

DynaQuip Controls • 10 Harris Industrial Park • St. Clair, MO 63077

Tel. 800-545-3636 • Fax. 636-629-5528 • www.watercop.com

receivers may have 6 dip switches . To match codes between 6 and 8

transmitters may have 6 dip switches . To match codes between 6 and 8 dip switch units, set switches

CLASSIC System should shut off the main water supply and then become inoperable

to return water service . Unplug the

CLASSIC

DQ PART NUMBER 192506 REV. C

CLASSIC