High End Systems HandShake Hızlı Başlangıç Kılavuzu - Sayfa 5

Aydınlatma Ekipmanları High End Systems HandShake için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. High End Systems HandShake 5 sayfaları. Controller for palm

Sayfayı Yazdır

TalkBack™ Protocol

TalkBack™ technology is a new feature that allows remote access to the menu system built into High End Systems fixtures. Any menu item

available is accessible remotely with Talkback protocol.

TalkBack protocol uses the normal DMX-512 connection for bi-directional communication with the fixture so you don't need physical access

to perform operations like changing a DMX address or configuring preset programs. You can configure any fixture supporting TalkBack

protocol on a DMX-512 link if you have access to the cable.

TalkBack protocol uses a discovery process to find the unique number that is embedded inside each fixture, similar to a serial number. The

HandShake controller utilizes this discovery process to find all the fixture on the link supporting TalkBack protocol.

Once the fixtures have all been identified, the current fixture parameter settings and information can be discovered. Fixture discovery can

happen at anytime, but the Talkback messages are only valid after the fixture starts homing.

TalkBack protocol utilizes the primary DMX link (pins 2-3) in a half-duplex communication mode. This means that it does not require pins 4-

5 to be connected or used to receive TalkBack messages coming from the fixture.

Identify Fixture

1. Tap to find all fixtures

on the link supporting

TalkBack protocol

Set Start Channel

1. Tap to select fixture

from pick list of HES

fixtures on link.

2. Tap pick list of function

groups and select Parameters

— remote access to fixture menus

2. Select the fixture for

communication

3. Tap pick list of function

groups and select Operations

3. Tap to popup pick

list of parameters

actions

4. Select Start Channel from

parameters action pick list

4. Tap Set to bring

up dialog box to turn

on FIxture ID

5. Select On to cause that fixture to strobe

wherever it is on the link.

Select Set again to turn the strobing to Off.

5. Tap Set button to go to dialog

box for setting parameters required

for selected action.

Tap Details to see all information and

parameter values for selected fixture.

6. Tap Get to retrieve

current setting