activTek INDUCT 2000LV Kullanıcı El Kitabı - Sayfa 8
Hava Temizleyici activTek INDUCT 2000LV için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. activTek INDUCT 2000LV 17 sayfaları. Electronic air purification system
Sayfayı Yazdır
R E P L A C I N G T H E B A L L A S T
CAUTION: Disconnect power at the breaker or fuse panel before servicing unit. Always
follow OSHA lockout procedures to prevent accidental exposure to electrical energy.
WARNING! - UV Light in operation. Disconnect unit from power cord before
servicing. Failure to follow warnings may result in severe eye damage.
Power
Cord
1
1. Disconnect (unplug) power cord from unit.
Always follow OHSA electrical lockout safety requirements
to prevent Accidental release of energy during service or
maintenance activities.
3
3. Disconnect all ballast wiring by pressing down on
connector tabs and pulling wire straight out.
5
5. Place new ballast into original location
and secure using the
two (2) nuts removed in step 4.
14
2
2. Open the ballast housing by
removing the four (4) screws then
removing the cover.
4
4. Remove the two (2) nuts
securing ballast to the case.
Remove the ballast.
R E P L A C I N G T H E B A L L A S T
6
6. To reconnect wiring, insert wire into wire pocket in ballast until bottomed. Gently pull
wire to ensure it is properly locked into place.
14
7
7. Replace cover and secure with
the original four (4) screws.
( co nt i n u e d )
8
LED INDICATOR
8. Re-install unit if removed from duct.
Reconnect power cord, turn breaker or
fuse power back on and check for
proper operation (LED indicator
should be lit when in operation).
15