Ihara Dot Inspector Hızlı Kılavuz - Sayfa 3

Büyüteçler Ihara Dot Inspector için çevrimiçi göz atın veya pdf Hızlı Kılavuz indirin. Ihara Dot Inspector 4 sayfaları. Multi-color viewing system

2. PRECAUTIONS

Every Dot Inspector is manufactured with the highest quality of workmanship. Please read the following

to information carefully to assure long-lasting operation with this instrument.

AVOID LOOKING DIRECTLY INTO THE LED.

STOP

AVOID LOOKING DIRECTLY AT THE SUN OR ANY BRIGHT LIGHTS WITH THE MAGNIFIER

STOP

AS IT MAY CAUSE SERIOUS DAMAGE TO YOUR EYES.

Turn off the instrument and remove the batteries if it is not being used for a long period of time.

Removing the batteries is to prevent possible damage due to leakage

The unit can be damaged if the polarity of the batteries is mistakenly reversed.

Remove the old dead batteries immediately to avoid battery leakage. Do not mix and match

batteries. Only use new, AAA Alkaline batteries as replacements.

Dropping or misuse of this device may cause serious damage.

Avoid operating in an area where the unit may be exposed to direct sunlight, high humidity or

extreme temperatures.

3. HOW TO USE

3.1 Magnifier Installation

The Dot Inspector is designed to allow you to quickly change the magnification. Ihara provides three

types of magnifiers -- Available in 20x, 30x and 50x.

1. Rotate the focus cap counterclockwise until it is removed.

2. Insert the magnifier halfway into the focus cap with slight pressure.

3. Position the focus cap on the Dot Inspector body and rotate it clockwise until it stops.

4. Press the magnifier down until the magnifier is properly seated.

3.2 Holding and Operation

The contrasting light enables the user to clearly view each Cyan, Magenta and Yellow dot, and the

overall image.

Cyan Images:

Magenta Images:

The Cyan key will enable the red LED.

The Magenta key will enable the green LED.