GALAXY SPAS PH-030/R1U Teknik Kitap - Sayfa 8

Isı Pompası GALAXY SPAS PH-030/R1U için çevrimiçi göz atın veya pdf Teknik Kitap indirin. GALAXY SPAS PH-030/R1U 12 sayfaları.

Installation

CAUTION

Do not install the unit in a place where ﬂammable gas leak can occur.

All plumbing connections should be carried out as per the instructions in this manual.

Failure to do so could result in water damage to property.

Avoid contact with the fan when the unit is operating as this will cause serious injury.

Ensure the Heat pump is correctly grounded to earth with the power cable.

Locating the Heat pump

The Heat pump should NOT be installed in an airtight location or conﬁned space, such as a basement or garage.

The Heat pump requires good air ventilation. It will discharge cold air when it is heating and hot air when it is

cooling, and its efﬁciency depends on its ability to draw normal ambient temperature air and discharge the

cold or hot air well away from the unit. It is recommended to install the Heat pump away from any other home

appliances, to avoid the chance of electromagnetic interference. Please refer to the "Air space requirements"

section of this manual.

The unit should be located on a solid ﬂat surface with a slight rearward slope. Ensure 3 meters (9 feet) of free air ﬂow to

the discharge panel and 1 meter (3 feet) to the inlet panel as well as free airﬂow to all sides of the unit. Ensure adequate

access for maintenance purposes.

In cold climates, the Heat pump should be installed at least 46 cm (18'') above the ground level on an open metal frame

in order to prevent the accumulation of ice at the base of the unit caused by condensation. Your Heat pump specialist

may recommend a dedicated frame rusted proof. See also recommendations in the Condensation section further.

Air space requirements

Air outlet

* Top clearance is only a recommendation to ease service.

3 m (9')

Air inlet