DCA Q1U-FF02-160 Çalıştırma Talimatları Kılavuzu - Sayfa 4

Mikser DCA Q1U-FF02-160 için çevrimiçi göz atın veya pdf Çalıştırma Talimatları Kılavuzu indirin. DCA Q1U-FF02-160 6 sayfaları. Electric mixer

INSTRUCTIONS FOR OPERATION

Installing or Removing Stirring Paddle

CAUTION:

Always be sure that the tool is switched off and unplugged before installing or

removing stirring paddle.

To install the stirring paddle, screw the stirrer

into the drive spindle and tighten the lock nut

securely. (Fig. 1)

To remove the stirring paddle, follow the

installation procedures in reverse.

Switch Action

To start the tool, simply pull the switch

trigger, release the switch trigger to stop the

tool. (Fig. 2)

CAUTION:

 Before plugging in the tool, always check

to see that the switch trigger actuates

properly and returns to the "OFF" position when released.

 Change the direction of rotation only when the tool comes to a complete stop.

Changing it before the tool stops may damage the tool.

-5-

Screw the auxiliary handle to the tool securely.

(Fig. 3)

CAUTION:

Always use auxiliary handle for safe operation.

Stirring Operation

When start stirring operation, put the stirring paddle into the material to be stirred firstly

before switching on the tool; And when stop operation, switch off the tool firstly and

wait until the tool has come to a complete stop before pulling the stirring paddle out.

CAUTION:

 Change the stirring operation only when the tool has come to a complete stop.

 Move the tool up and down while stirring.

 Clean the stirring paddle after use.

CAUTION:

Always be sure that the tool is switched off and unplugged before attempting to

perform inspection or maintenance.

1. Inspecting the Mounting Screws

Regularly inspect all mounting screws and ensure that they are properly tightened.

Should any of the screws be loose, retighten them immediately. Failure to do so

could result in serious hazard.

2. Maintenance of the Motor

The motor unit winding is the very "heart" of the power tool. Exercise due care to

ensure the winding does not become damaged and /or wet with oil or water.

-6-