Autonomous Anti-collision Smartdesk Montaj Talimatları Kılavuzu - Sayfa 10

İç Mekan Mobilyaları Autonomous Anti-collision Smartdesk için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. Autonomous Anti-collision Smartdesk 12 sayfaları.

Sayfayı Yazdır

Changing the Desktop Height Displayed

The function enables you to change the height shown on the display based on the

actual measurement.

NOTE: Before using this function, execute the Manual Reset procedure.

Press and hold "M" key till the display shows "Ur" and "oFF" alternately.

Press "up" key till the display shows "End" and current height alternately.

( for metric units, please note that the unit is "mm" during this procedure)

Changing the height by pressing "1" key to adjust the first number, "2" key to

adjust the second number, and "3" key to adjust the third number.

Press "M" and the height will be adjusted to defined digit.

Anti-Collision Function

Once the desktop encounters any obstacle in its path, the screen displays

"E-2".

The desktop will move a short distance in opposite direction, and will

operate normally after the obstacle has been removed.

Plug Detection

Once the display shows "E-3" and "rES" alternately, it reminds you check

whether any motor connected to control unit has failed.

Please power off the whole system, check and connect all the cables,

then power back on.

Press and hold "down" key when the display shows "E-1", the desktop will

move slowly down and return back till the display shows "60".

NOTE: The Anti-Collision function and the High & Low Limitation Positions function are

not enabled during this procedure. Please note that there is a potential risk of pinching

in this case, and be sure no obstacles are in the desk's path.

Reset Control Unit to Factory Settings

With this function, you can return the control unit to factory settings.

Press and hold "M'' key till the display shows "FAC''

Press "M" key, and the control unit will restore itself to factory settings

(including memory positions, high and low limitation positions, etc.).