Autool BT-660 Kullanıcı Kılavuzu - Sayfa 3

Test Ekipmanları Autool BT-660 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Autool BT-660 5 sayfaları. Battery system tester
Ayrıca Autool BT-660 için: Kullanıcı Kılavuzu (9 sayfalar)

Sayfayı Yazdır

•

Input rated capacity; you can see the starting current standards

in front of the battery. Such as BCI/300A.

•

Then press OK key to start testing.

Note

For power loss battery (such as a vehicle for a long time on

hold,the battery is not charged in time; forget to close the lights,

the doors resulting in serious loss of battery electric vehicle and

can not be started, etc.), in the actual testing process may also

be prompted to "Please replace the battery," for such batteries,

please consult the battery manufacturers, and then tested.

Cranking Test

Following:

•

Starting the engine as prompted,

tester will automatically coplete the

cranking test and display the result.

•

Normally, cranking voltage value lower

than 9.6V is regarded as abnormal and

it is OK if it is higher than 9.6V.

Test result of the tester includes actual

cranking voltage & actual cranking time.

•

When cranking test is abnormal,

battery test result will also be

displayed at the same time.

•

This is for the convenience of the

maintenance personnel to quickly

know the whole state of the starting

system according to the data.

Charging Test

•

When enter the charging test, tester

will prompt "Loaded testing"

NOTE: Do not shut down the engine during the test. All electrical

appliance and device are in OFF state. Turn on/off any electrical

appliance in the vehicle during the test will affect the accuracy of

the test result.

•

Operate accordingly to increase the

engine rotating speed to 2500turns,

and keep for 5 seconds.

•

Tester starts the charging volt test

after increase rev detected.

•

After the test finished, tester displays

the effective ,charging ,volts, tipple

test result and charging test result.