Autopage RS-602 Kurulum Kılavuzu - Sayfa 11

Uzaktan Çalıştırıcı Autopage RS-602 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Autopage RS-602 16 sayfaları. Professional remote car starter
Ayrıca Autopage RS-602 için: Kullanım Kılavuzu (8 sayfalar)

Sayfayı Yazdır

A. PROGRAMMING TRANSMITTER:

Note: This remote start system will only retain the last 4 remote transmitters programmed. If the transmitter memory is

exceeded, the security system will start deleting transmitters from memory in chronological order.

PROGRAMMING THE REMOTE TRANSMITTER

1. Turn the Ignition 'switch 'OFF/ON' 3 TIMES and stay in the 'ON' position. Within 15 seconds.

2. Push the Programming switch 2 times holding in on the 2

starts to flash then release the valet switch. You are now in the Transmitter programming mode.

3. Press the 'Lock' button on the transmitter until a chirp from the horn / a flash from the parking light / the LED turns on

for 2 seconds to confirming the first transmitter is now programmed.

4. Apply the same procedure (step 3) to program 2

Exit: Turn Ignition to 'OFF' position, or leave it for 15 seconds. 3 long chirps & 3 parking light flashes will confirm exit.

B. FEATURES PROGRAMMING:

FEATURE "

" PROGRAMMING:

1. Turn the Ignition 'switch 'ON/OFF' 3 TIMES and stay in the 'OFF' position.

2. Push the Programming switch 1 time and hold it until the LED turns on and (*) one chirp with a long chirp is heard

then release the Programming switch. You are now in the feature 'I' programming mode.

3. Press and release the transmitter button with the Icon corresponding to the feature with the icon you want to program.

a. The (optional) horn chirps and the LED will flash then pause indicating a previous setting.

b. The factory default settings are always [1] LED flash, [1] horn chirp.

4 Depress the transmitter button icon again to change the feature. Simply keep re-depressing the transmitter button icon

again until the module advances to your desired setting.

5. Depress the next desired transmitter icon button corresponding to the feature you want to program.

Press

One Chirp /

Transmitter

LED one pulse

Button

Factory Default Setting

H3/2 White/Blue = 1 Pulse

Remote Start

H3/8 Pink Wire = Factory

Security Disarm Signal Output

H2/4 Brown Wire = Horn Output

Button Two Push Remote

Without ignition controlled door

locks & unlocks

(*) The Horn must be connected to hear the programming chirps.

Exit

: Turn Ignition to the 'ON' position, or leave it for 15 seconds. 3 long chirps & 3 parking light flashes will confirm exit.

RS-602 REV A.

PROGRAMMING

push, until a long chirp from the horn (optional) and the LED

, 3rd and 4th

Two Chirps /

LED two pulse

H3/2 White/Blue = 3 Pulse

Remote Start

H3/8 Pink Wire = Start Status

(Shock Sensor Bypass Control)

Output

H2/4 Brown Wire = Rearm Signal

Output

Button One push Remote

Start

Ignition controlled door locks &

unlocks

6/18/2007

Three Chirps/

LED three pulse

H3/8 Pink Wire = 20 Second

Ground out Key Sensor By-pass