High Sec Labs FICE11PH-M Hızlı Kurulum Kılavuzu - Sayfa 8

Genişletici High Sec Labs FICE11PH-M için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. High Sec Labs FICE11PH-M 9 sayfaları. Secure kvm extenders

Sayfayı Yazdır

Table of Contents

SECTIONS

OPERATION

Running an EDID Capture

Before using the Extender, run a one-time EDID capture on both sides – Transmitter

and Receiver. This prevents the continuous transfer of potentially malicious data -

from the display to the PC – that could infect the PC, cause data leakage, and so on.

Preparation:

•

Connect the PC and all peripherals to both the units, according to the

Installation Instructions.

•

Make sure the PC, display, and the units are ON.

To run an EDID capture:

On the Transmitter, short-click the EDID Lock button – for less than one

second.

Warning: Long-clicking the EDID Lock button sends the unit into an

undesired loop. If this happens, restart the unit and repeat the

procedure.

At first, the EDID LED flickers for a few seconds and then, once captured

lights green continuously.

Make same on the Receiver, short-click the EDID Lock button – for less

than one second and wait until the EDID LED will light green continuously.

Note: If the EDID LED is OFF, check the connections and that the PC or

the Display are powered ON. Then, repeat the procedure.

3. Restart both units.

HSL Secure Extended Isolators Quick Setup Guide

EDID Lock button

Note: An EDID capture needs to be

performed for new installations and

when changing a display.

EDID LED

Transmitter

EDID LED

HDC19956 Rev.1.0

Receiver