Autopage AP4000EX Kullanım Talimatları Kılavuzu - Sayfa 5

Araba Alarmı Autopage AP4000EX için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Autopage AP4000EX 17 sayfaları. Access point
Ayrıca Autopage AP4000EX için: Kullanım ve Kurulum Kılavuzu (15 sayfalar)

Sayfayı Yazdır

If the AP4000EX is to be connected through the vehicle's fully automatic power antenna, it will be necessary to locate

the wire from the vehicle radio to the power antenna relay which signals the antenna to raise or lower. This wire will

show voltage each time the radio is switched "on", allowing the antenna to raise. When the radio is switched "off",

voltage will be eliminated and the antenna will lower.

At this time, determine a switched ignition source from the vehicle, and if installing with an alarm system, determine if the

alarm system triggers positive or negative if the alarm does not have a separate pager trigger output.

After performing the above tests, DISCONNECT THE MAIN BATTERY POWER OF THE VEHICLE!

WARNING! DO NOT INSTALL THE AP4000EX TRANSMITTER OR ITS ANTENNA NEXT TO ANY

VEHICLE'S COMPUTER, NOR ANY AUDIO SYSTEM COMPONENT THAT USES A SWITCHING

POWER SUPPLY. The radio frequency energy from the transmitter may cause interruption or improper operation of

such devices. AutoPage does not accept any liability for any losses or damage, whatsoever, resulting from such

operation.

CONTENTS

AP4000EX main control unit = 1

AP4000EX paging receiver = 1

6 wire harness = 1

2 wire harness = 1

Call button = 1

Radio cable (coax) jumper = 1

Warning decal = 2

Installation/User manual = 1

WIRE HARNESS CONNECTIONS & WIRE IDENTIFICATION

2 Wire Harness

1. RED w/fuse connector = Main power supply.

2. BLACK = Main system ground.

6 Wire Harness

1. WHITE = Switched ignition input.

2. GRAY = Negative trigger input.

3. VIOLET = Positive trigger input.

4. YELLOW = Fully automatic antenna output control. (*)

5. PINK = Optional shock sensor input.

6. GREEN = Call button input.

(*) Requires optional relay. See cautions in this manual regarding connection of this output.

WARNING: INSTALL THE SYSTEM WIRING SO THAT POWER CONNECTIONS ARE MADE AFTER

THE ANTENNA AND ALL OTHER CONNECTIONS HAVE BEEN MADE. REPEATED TRIGGERING OF