Autopage C3-RS-915 LCD Kullanım Kılavuzu - Sayfa 8

Araba Alarmı Autopage C3-RS-915 LCD için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Autopage C3-RS-915 LCD 17 sayfaları. Professional 2-way lcd remote car starter & alarm system with built in temperature & voltage sensor and two-way serial port data link

Sayfayı Yazdır

Autopage C3-RS-915 LCD Kullanım Kılavuzu

SVMASTER

Under ignition ON, press and hold the

parking lights will turn on for 1.5 seconds to indicate the system has entered the anti car-jacking

mode.

2. Once the system in anti car-jacking mode, the system will be triggered when any door is

opened and closed while the ignition is "ON".

PASSIVE ANTI CAR- JACKING: (Programmable)

It will operate as noted below:

1. Turn the ignition switch to the "ON" position and the system will arm.

2. Once the system is armed, if you are forced from the vehicle, the system will trigger when the door is

opened and closed while the ignition is "ON".

TRIGGERING THE ANTI CAR -JACKING MODE:

A). 50 seconds after the system has been triggered. The siren will start chirping for 15 seconds.

B). During this 15 second period of chirping, you will be alerted to push the valet switch once to turn off the

car-jacking feature. If not, it will enter a second timer for carjacking.

C). 65 seconds after the system has been triggered, the siren will start sounding and the parking lights will start

flashing.

D). 90 seconds after the system has been triggered,

The siren will sound and the parking lights will flash, and

The starter disable will activate to prevent the vehicle from starting.

It will remain active until the vehicle's battery power is exhausted.

OVERRIDE THE SYSTEM TO TURN OFF ANTI CAR- JACKING:

Turn the ignition switch from OFF to ON, and within 10 seconds push valet switch, the siren will stop and the

system disarmed

Note: If you use password pin code to double protect the vehicle security, you will need to use it to completely

disarm the system.

N. SYSTEM'S TRIGGER CHECK

Press and hold

the LCD remote will show "ALARM " icon flash on text area (see advanced users mode), then

press

button to activate system trigger check.

Note: If the system has no response then you are out of range.

O. SYSTEM'S STATUS CHECK

button of LCD remote until 3 beeps sound , the LCD remote will show "STATUS " icon

Press

flashing in the text area (see advanced users mode), then press

check.

It responds with one melody sound and all vehicles' status records will immediately displayed on the

LCD screen.

Note: If it has no response then you are out of range.

P. DRIVER PAGING / LOST & FOUND (

This feature is useful the event that someone wants to page the driver of the parked vehicle or

someone cannot find his LCD remote transceiver.

Under the ignition switch "OFF" condition, press and hold the valet switch for 2 seconds to page the

driver, one chirp sound shall be emitted from the vehicle and the paging melody sound continues

sounding from the Remote LCD transceiver.

Q. DOME LIGHT CONVENIENCE SUPERVISION (Optional Feature)

The alarm has a unique feature that will turn on your vehicle dome light as follows:

1. Upon disarming, the interior light will remain on for 30 seconds.

2. If the vehicle is intruded, the interior light will flash for the same duration as the siren.

Note: Turning on the ignition switch or arming the alarm will turn off the dome light.

SVMASTER

C3 RS915 REV. O1

(For two-way transceiver operation only)

button of LCD remote until 3 beeps sound , release and re-press

(For two-way transceiver operation only)

and

buttons at the same time for 2 seconds. The

button to activate system status

For two-way transceiver operation only)

http://www.msvmaster.lv

button again,