Autopage RF-303 Çalıştırma Talimatları Kılavuzu - Sayfa 9

Araba Alarmı Autopage RF-303 için çevrimiçi göz atın veya pdf Çalıştırma Talimatları Kılavuzu indirin. Autopage RF-303 18 sayfaları.

3. To terminate the trigger test, push the ON/OFF button on the remote

transmitter.

NOTE: If triggered in the armed mode, the RF-303 will sound the vehicle horn,

or siren and flash the parking lights for 60 seconds. It will then stop and

automatically reset, and rearm. If the violation continues, the alarm will sound

and the parking lights will flash for two (2) sixty second cycles.

J. PROGRAMMING THE REMOTE TRANSMITTERS

The RF-303 includes two (2), 2 button mini remote control transmitters which

must be programmed to the alarm before any alarm function is possible. This

action is normally done at the time of installation, however there may be

occurrences where you wish to enter the program mode.

NOTE: Each time the programming mode is entered, all previously programmed

transmitter codes will be automatically deleted and must be reprogrammed. This

is an important security feature. If any transmitter is lost or stolen, enter the

programming mode and reprogram existing transmitters. Transmitters can only

be programmed by entering the programming mode.

NOTE: Any transmitters programmed to the RF-303 as described above will

remain in memory during times when certain vehicle service procedures make it

necessary to disconnect the battery.

To program the RF-303 transmitters, follow the directions as written below, in

their exact order! HAVE ALL TRANSMITTERS READILY AVAILABLE.

1. Flip the VALET/OVERRIDE switch to its "ON" position.

2. Turn the ignition switch to "ON", then "OFF", then immediately flip the

VALET/OVERRIDE switch "OFF", "ON/OFF", "ON/OFF". The vehicle

horn, or siren will chirp several times.