Autopage RF-420LCD Kurulum Kılavuzu - Sayfa 11
Araba Alarmı Autopage RF-420LCD için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Autopage RF-420LCD 12 sayfaları. Professional vehicle security system
Sayfayı Yazdır
ALARM FEATURE "C" PRORAMMING:
1 Turn the Ignition 'switch 'ON/OFF' 3 TIMES and stay in OFF position.
2 Push the Valet switch 7 times and hold in on the 7
then release the valet switch. You are now in the Alarm feature 'C' programming mode.
3 Press the transmitter button corresponding to the feature you want to program.
One Chirp /
Press
LED one pul s e
Transmitter
Factory
Button
Default Setting
Channel 2
1
Output =
2 sec. Pulse
Channel 3
2
Output =
Momentary
Pink Wire =
3
2 Step Unlock
Channel 4
4
Output =
2 sec. Pulse
Exit: Turn Ignition to 'OFF' position, or leave it for 15 seconds. 3 long chirps and 3 Parking
Light will confirm exit.
Channel 2/3/4 Timer Control Output Programming:
Enter:
1.
Turn the Ignition 'switch 'ON/OFF' 3 TIMES and stay in OFF position.
2.
Push the Valet switch 7 times and hold in on the 7
then release the valet switch. You are now in the Alarm feature 'C' programming
mode.
Timer Program Channel 2/3/4:
1-a. CH2 Press and release the transmitter
chirp to indicate you are in features "Channel 2 Timer Programming mode".
1-b. CH3 Press and release the transmitter
chirp to indicate you are in features "Channel 3 Timer Programming mode".
1-c. CH4 Press and release the transmitter
chirp to indicate you are in features "Channel 4 Timer Programming mode".
2.
Press and hold the valet switch, the timer will immediately start.
3.
When the desired interval has passed, release the valet switch. 1 long chirp for
confirmation.
(Set to any interval between 1 second and 2 minutes)
Note 1:
If your built-in timer controls window/sunroof closure in your car DO NOT change the timer
setting! This requires installer-only programming. Changing the value will adversely effect
operation and may cause damage.
Note 2:
Momentary output = The momentary output selection will output a negative signal from
the Channel 2,3 or 4 output immediately when the channel 3 or 4 button is pressed and will
continue until the button is release.
Latched output = The latched output selection will output a negative signal as soon as the
Channel 2,3 & 4 button is pressed and will continue until the button is pressed aga i n .
th
push, when a long chirp is heard,
Two Chirps /
Three Chirps /
LED two
LED three pulses
pulses
Channel 2
Channel 2 Output =
Output =
Timer control
Latched
Channel 3
Channel 3 Output =
Output =
Timer control
Latched
Pink Wire =
Factory Disarm
Channel 4
Channel 4
Output =
Output =
Momentary
Latched
th
push, when a long chirp is heard,
button 3 times, [3] LED flash, [3] siren/horn
button 3 times, [3] LED flash, [3] siren/horn
button 4 times, [4] LED flash, [4] siren/horn
11
Four Chirps /
LED four
pulses
Pager Output
Pager Output
Channel 4
Output =
Timer control