Autopage Telematics and Tracking Module Kurulum Kılavuzu - Sayfa 5
Araba Alarmı Autopage Telematics and Tracking Module için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Autopage Telematics and Tracking Module 8 sayfaları. Telematics and tracking module
Ayrıca Autopage Telematics and Tracking Module için: Kullanım Kılavuzu (16 sayfalar)
Sayfayı YazdırThe C|3 has 2 data plugs that need to be connected correctly for the
system to operate. These inputs are labeled and cannot be
interchanged. These cables will control the alarm and remote start
system as well as the data module if used. The cables can be
interchanged but they need to be connected to the proper socket for
correct operation.
Data Cable "A": This cable can be attached to an ADS data
module. This connection does not need to be made if no data
module is required for the installation.
Data Cable "B":
connector B and to the data port of the Auto Page alarm
or remote start system.
commands to the unit.
These data cables are encrypted and will ONLY work with Autopage C|3
compatible products and ADS data modules. Please insure the latest
software has been downloaded to the ADS module. Autopage One way
ADS units will operate but will have limited functionality. Please be sure
to chose the two-way protocol if available when updating or downloading
your ADS data module.
Antenna Mounting:
The C|3 unit comes with a combination GPS and GSM antenna. This
antenna should be mounted on the dash or rear deck of the vehicle with
a good view of the sky above. This is important for maximum
performance of the C|3 unit and these are the preferred locations. These
antennas can be mounted below a plastic dashboard or installed in the
dash but this will affect the performance of the antenna. Where a strong
cellular and GPS signal is present it is possible to mount these units
This cable must be connected to
This is vital to communicate