High Tech Gio-Bella HTH 888 Manuel - Sayfa 14

Su Filtrasyon Sistemleri High Tech Gio-Bella HTH 888 için çevrimiçi göz atın veya pdf Manuel indirin. High Tech Gio-Bella HTH 888 16 sayfaları. Point of use residential water alkalizer for drinking and cooking

Sayfayı Yazdır

c) Alkaline level preset adjustments:

i. [neutral] + [acidic], press [alkaline] or [acidic] to

ii. once the desired preset level is displayed, press

iii. use [alkaline] or [acidic] to index to desired power

13.

Trouble shooting – It is not likely that you will experience

any problems with your new Gio-Bella, but in the event you do,

refer to the chart below before calling your dealer:

SYMPTOM

Water is turned on but nothing

happens.

Filter life indicator still reads 9999

even though I changed the filter.

The ionized water has developed

a fishy or otherwise objectionable

smell or taste.

strongest acid and 1 for the weakest. Using

[alkaline] to increase and [acidic] to decrease, select

the desired value and press [neutral] + [alkaline] to

enter.

access level 1 (display 0005), level 2 (display 0006),

level 3 (display 0007), and level 4 (display 0008).

[neutral] to display current preset value of 1 to 100.

and press [neutral] + [alkaline] to enter value.

IMPORTANT – ALWAYS USE SUPPLIED TEST

KIT TO MEASURE RESULTING pH AFTER

ADJUSTING THE PRESETS.

POTENTIAL CAUSES

Diverter valve button not pulled

out.

Rear panel main power switch is

OFF.

Fuse has blown.

Circuit breaker has tripped.

Hose from diverter connected at

acid discharge instead of water

input.

Filter life counter was not reset

during filter change.

There is too high a level of

alkaline minerals.

Filter cartridge is depleted.

SOLUTION

Verify that water is on and that

divert button is pulled.

Verify that rear panel main power

is ON.

Verify that water hose is correctly

connected to "Water Inlet" and

secured with clamp.

Check for power at outlet by

plugging in something known to

work.

Remove fuse and verify OK

condition. Replace fuse with

250 V @1 amp if burned out.

Notify your dealer if none of the

above solves the problem.

Press and hold red filter "Reset"

button with power on until

indicator reads 9999.

Use a lower ionization level. If no

improvement, replace filter

cartridge. Replace or start using

the calcium cartridge. Check with