Dynasound DS1628 Kullanıcı Kılavuzu - Sayfa 4

Amplifikatör Dynasound DS1628 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dynasound DS1628 5 sayfaları. Digital power amplifier

Sayfayı Yazdır

HPF Switch: This DIP switch provides a High-Pass Filter for the amplifier input. The High-Pass Filter is used to eliminate unnecessary

lower frequencies. From the factory, the High-Pass Filter is set to 125 Hz. CAUTION: To avoid output fault conditions, the High-Pass

Filter should be set to 125 or 200Hz. when driving 70-Volt speaker systems.

Output:

These screw terminals provide the speaker outputs from the amplifier.

Remote:

These terminals provide remote Power On/Off capabilities.

Power:

The switch applies AC power to the unit.

AC Power Entrance: The receptacle accepts the detachable AC Power Cord. The AC Power Cord is for connection to three-prong

grounded AC outlets. CAUTION: Do not remove or defeat the ground prong on the AC Power Cord, as this constitutes a shock hazard.

Disconnect Device shall remain readily operable.

Maximum Ambient Operating Temperature

70.7v Output Power

Load Impedance

Frequency Response

Full Power Bandwidth

Signal to Noise

Input Sensitivity

Standard Voltage Gain

Input Impedance (Balanced/Unbalanced)

Input Connectors

Output Connectors

Class

Power Supply

Cooling

Controls

LED Indicators

Construction

Weight

Dimensions

SPECIFICATIONS

40 C

80 watts per channel – 2 channel

62 ohms minimum

20 Hz – 20 kHz (Filter Bypassed)

± .7 dB

>90 dB

1V (0 dBV)

37 dB

10k Ohms / 5 k Ohms

Phoenix Type

High Speed Switching

Convection with Auxiliary Fan

Power On/Off, Channel Gain, Hi-Pass

Power, Signal Present and Clip

Steel and Aluminum Chassis

7.0 lbs

1 R/U 19" inch Rack Mount 11" deep