High Tech Pet Products BLUEFANG X-22 Kurulum, Kullanım ve Eğitim Kılavuzu - Sayfa 4

Evcil Hayvan Bakım Ürünü High Tech Pet Products BLUEFANG X-22 için çevrimiçi göz atın veya pdf Kurulum, Kullanım ve Eğitim Kılavuzu indirin. High Tech Pet Products BLUEFANG X-22 16 sayfaları. Super electronic dog fence

Sayfayı Yazdır

PART 1 – INTRODUCTION

SYSTEM COMPONENTS:

Your

System includes the following items.

(1) Model TX- Transmitter Base Station

(1) Model

(1) DC Adapter

(500 feet) High Quality Boundary Wire

(50) Boundary Flags

(3) Improved Waterproof Wire Splices

(1) Replaceable Receiver Collar Battery Pack

(4) Mounting Screws (for your transmitter)

KEY FEATURES:

Pulsed Proportional Stimulus: Our unique Pulsed Proportional Stimulus

System is what makes the

other systems made. A computer chip inside the

receiver collar actually detects the distance of your pet from the

boundary wire by measuring the relative radio signal strength. It then

applies a combination of sound and shock stimuli in inverse proportion to

the distance from the boundary wire. In other words, the closer your pet

is to the boundary wire, the more sound and shock stimulus is applied.

______________________________________________________________________________________

www.hightechpet.com

Receiver Collar

Figure 1

system stand apart from all

High Tech Pet Products, Inc.

Contain system that is working, test your collar(s) on their operating

system by holding your collar next to their collar in the yard. As you

move both collars toward the wire loop both collars should beep at

about the same rate. If this is true your collar(s) is working and your

Base Station Transmitter has failed – repair or replace.

g) If you cannot determine which component has failed, return both

the collar(s) and the Base Station Transmitter to High Tech Pet

Products for analysis and repair.

3) Test the Containment Loop

1) and 2) above, disconnect the Test Loop Wire and re-connect

the containment wire loop to the Base Station Transmitter. Place

in a "clean" area of the yard. Clean means with the least amount

of metal or concrete nearby (concrete may contain metal re-bar).

This area should be free of underground pipes if possible.

Face the collar toward the wire. This makes the face almost

parallel to the wire at that point.

j) Turn on the Base Station Transmitter, set the Boost Power switch

to normal (NOR), and adjust the Field Strength Control Knob to

maximum (fully clockwise). If the BREAK DETECTION indicates a

break then the loop is broken and needs repair. Go to step 4).

the face of the collar. If not, the loop is intermittent and needs

repair. Go to step 4).

Slowly adjust the Field Strength Control Knob on the transmitter

counter clockwise until the collar stops beeping. If the collar is

still beeping when the Knob is fully counter clockwise, the Base

Station transmitter is faulty – repair or replace.

m) Slowly adjust the Knob clockwise and note the beeping starts

at a rate of about one beep every half second. Continue slowly

adjusting clockwise and note the beeping rate increases to

two short beeps every half second. Continue slowly adjusting

clockwise and note the collar beeping at an even higher rate that

sounds like a string of beeps every half second. This means the

loop and the entire system are working properly. If not the loop

is intermittent. Go to step 4).

___________________________________________________________________________________________

High Tech Pet Products, Inc.