Dynasty EF68-72 Series Ev Sahibinin Kurulum Talimatları ve Kullanım Kılavuzu - Sayfa 6
Kapalı Şömine Dynasty EF68-72 Series için çevrimiçi göz atın veya pdf Ev Sahibinin Kurulum Talimatları ve Kullanım Kılavuzu indirin. Dynasty EF68-72 Series 8 sayfaları. Wall mounted electric fireplace
Sayfayı YazdırA 15 AMP, 120 Volt, 60 Hz circuit with a properly grounded outlet is required. The unit comes standard with 6 feet (1.8 m)
three wire cord, exiting from the rear of the fireplace. Plan the installation to avoid the use of an extension cord. Preferably,
the fireplace will be on a dedicated circuit as other appliances on the same circuit may cause the circuit breaker to trip or
the fuse to blow when the heater is in operation.
Clean the metal trim using a soft cloth, slightly dampened with citrus oil based product and buff with a clean soft cloth. DO
NOT use brass polish or household cleaners as these products will damage the metal trim. Citrus oil based products can
be obtained at supermarkets or hardware stores.
WARNING: ALWAYS UNPLUG THE CORD BEFORE MOVING OR SERVICING.
DO NOT IMMERSE HEATER IN WATER!
Always turn OFF the heater and disconnect the cord from the electrical outlet before cleaning your heater.
Light accumulated dust may be removed from the heater with a soft cloth or vacuum cleaner.
Wipe the exterior surfaces of the heater occasionally with a slightly damp cloth (not dripping wet) using a solution
of mild detergent and water. Dry the case thoroughly before operating the heater.
Caution: Do not allow water to run into the interior of the heater as this could create a fire or electric shock hazard.
The fan motor is factory lubricated for life and will not require further lubrication.
Store heater in a clean dry place when not in use.
Warning: Any other servicing needed must be performed by an authorized service representative. Do not attempt to
service the unit yourself.
1
2
Fig. 5
ELECTRICAL CONNECTION
CLEANING TRIM
MAIINTENANCE
1
2
Fig. 6