Dynasty Fireplaces DY-BTW40 Ev Sahibinin Kurulum Talimatları ve Kullanım Kılavuzu - Sayfa 14

Kapalı Şömine Dynasty Fireplaces DY-BTW40 için çevrimiçi göz atın veya pdf Ev Sahibinin Kurulum Talimatları ve Kullanım Kılavuzu indirin. Dynasty Fireplaces DY-BTW40 16 sayfaları.

Sayfayı Yazdır

1. Remote Control

Remote Control

Aim the remote control at the remote receiver. Make sure you hear a beep

NOTICE

each time you press the button! If not, the fireplace will not respond to the

signal.

BUTTON

ON: Turns on.

Note:

All the functions are off in the standby mode, it

will memorize the working condition of flame

effect and heating.

ON/OFF

OFF: Returns the unit to standby mode.

Controls the flame effect brightness.

Cycles through 4 levels of flame brightness .

FLAME

Press once turns Fan on, and 10s later Low

heat on. (Pilot lights illuminated ●○)

Press again turns on High heat. (Pilot lights

illuminated ●●)

Press third time turns heat off. 10s later fan off

HEATER

(Pilot lights illuminated ○○)

Controls the thermostat setting.

Thermostat: Automatically turns the heater

on and off to maintain the temperature.

If the thermostat is set below the room

temperature, the heater will turn off.

NOTE: The thermostat only works when the

heater is on.

1) NOTE: The heat will not change as the room

temperature change when

temperature shows on the remote screen.

NOTE: It will change between C and F after

TEMP

pressing

corresponds to 16-28C. It can not be

operated in the standby mode, but the

temperature still displays on the remote

control screen.

Controls the timer settings.

The timer turns off the fireplace at the set time,

from 0.5 hours to 9.0 hours.

TIMER

Controls the LED light strips at the bottom of

the fuel bed.

FUEL BED

FUNCTION

the

button

for

1. Press. The flame effect and the

remote control functions are enabled.

The flame setting will display on the

remote control screen.

2. Press. The flame effect and all the

functions will turn off. The remote

control screen will go blank.

1. Press once to turn the flame effect

on.

2-4. Press again to cycle through 4

levels of flame brightness .

1. Press. The heater turns on low

heat.

2. Press. The heater turns on high

heat.

3. Press. Turn off the heat.

1. Turn the heat on. Press.

The temperature displays 24C.

2-13. Press again to increase the

temperature by 1C interval up from

16C to 28C (maximum setting).

14. Press again. The thermostat

turns

displayed.

there is

15. Press. Start at 23C.

3s.

60-84F

1-10. Press .

Timer setting: 0.5H, 1.0H,

and then each hour up to 9.0H.

11. Press. Off. No time is displayed.

1. Press once to turn the fuel bed

light on.

2-14. Press again to cycle through

14 color options of the fuel bed.

ACTION & INDICATION

off.

temperature