High-End Technology F-20 Montaj Kılavuzu - Sayfa 17

Oyuncak High-End Technology F-20 için çevrimiçi göz atın veya pdf Montaj Kılavuzu indirin. High-End Technology F-20 18 sayfaları.

FAN MOUNTING CONTINUED

PICTURE ON LEFT: You can use a Ruler to pull the tape on the inside of the thrust tube. The front diameter is

determined by your choice of fan. Wrap the plastic around the fan. The rear diameter should be about 80MM which is the

diameter of the tail cone of the F-20

PICTURE ON LEFT: Once you have it ready, fold the thrust tube into a "C" shape and insert from the back of the jet.

SETTINGS:

Ailerons .38 Low High.50 measured at the middle of the aileron.

Elevator .75 Low High 1inch (Trailing edge set so the bottom of the elevator is flush with the

bottom of the fuselage).

Rudder: 1 Inch or as much as you can get

Flaps: 1 Inch OPTIONAL (WARNING: The F-20 will climb when the flaps are lowered)

CG 9.00" 228.6MM Measured from the intake back into the wing.

PICTURE ON LEFT: Aileron LOW Rate travel measured half way out on Aileron.

PICTURE ON LEFT: CG is 9 inches from the INTAKE back.