Autopot AQUAvalve5 Basit Bakım Manüelleri - Sayfa 2
Sulama sistemi Autopot AQUAvalve5 için çevrimiçi göz atın veya pdf Basit Bakım Manüelleri indirin. Autopot AQUAvalve5 2 sayfaları.
Sayfayı Yazdır
60Pot system contents
• 1x 400 litre FlexiTank
• 1x 16mm cross connector
• 60x 1Pot tray and lid
• 30x 16 - 9mm cross connector
• 60x 15 litre pot
• 25 metres of 16mm pipe
• 60x AQUAvalve5
• 30 metres of 9mm pipe
• 1x 16mm click-fit tank adapter and filter
• 60x marix disc
• 3x 16mm inline tap
• 60x root control disc
Reference: 9mm pipe - Outside ø 9mm/Inside ø 7mm
Suggested layout
System requires minimum
400 litre FlexiTank (supplied)
400 ltr
FlexiTank
400 ltr
FlexiTank
Elevate tank
150mm from
floor to maintain
gravity pressure
AQUAvalve5
16mm click-fit tank adaptor & filter
9mm pipe
16mm pipe
•
Pot up your plants, water through, then allow your plants to establish in the pots for a period of 7 to 10 days before
turning your system on. This will encourage a stronger and healthier root system.
•
Always raise your reservoir to a minimum of 150mm above the highest AQUAvalve and re-fill the reservoir when there
is approximately a 1/3 of the solution left - NEVER ALLOW THE RESERVOIR TO RUN EMPTY.
•
With AQUAvalve5 systems mineral or organic fertilisers may be fed via the reservoir and pipework. Organic fertilisers
will require a water pump in the reservoir running for 15 mins every 2 hrs and cleaning of the reservoir, pump, and
filter each time the reservoir empties. Flush pipework with plain water every time the reservoir empties.
•
Clean all substrate from the bottom and sides of the pots before placing in trays to ensure AQUAvalve functionality.
•
Always use free draining substrates, for example: soil/perlite, coco/perlite, soil/clay pebbles, coco/clay pebbles,
rockwool/clay pebbles.
[email protected] I www.autopot.co.uk I +44 (0)1276 534894
Plan views
and options
16mm pipe - Outside ø 16mm/Inside ø 13mm
16mm – 9mm cross connector
16mm cross connector
16mm in-line tap
Advice
1Pot dimensions
1
Put black marix
disc in pot
3
Remove collar
Push 9mm pipe through
collar and attach to
AQUAvalve nozzle
Rescrew collar - DON'T
overturn... when you
feel it grip STOP
5
Position tray
so it is level
Insert root control
disc Gold face up
7
According to the size of your system connect your
9mm/16mm pipe to relevant fitting or tank...
Using your front instruction sheet, repeat the module set up instructions for the number of trays.
Allow your plants to establish for 7-10 days before turning system on
Advice
If you require any guidance email - [email protected]
1Pot setup
instructions
400 L
FlexiTank
680mm
2
Fill pot with medium
and pot up plants.
Water through pot
and allow to drain
outside the tray.
4
Connect AQUAvalve
so 'half moon' is on
T section in the tray
6
Cut 9mm/16mm pipe
to appropriate length
8
Place
pot
in
the
tray, make sure it is
CLEAN!
Place lid over valve
onto tray