Autopot Easy2grow 40 Kurulum Manüelleri - Sayfa 2
Sulama sistemi Autopot Easy2grow 40 için çevrimiçi göz atın veya pdf Kurulum Manüelleri indirin. Autopot Easy2grow 40 2 sayfaları.
Sayfayı Yazdır
easy2grow 40 contents
• 1x 400 ltr FlexiTank
• 10x 16 - 6mm cross connector
• 20x 2Pot tray & lid
• 1x 16mm tee connector
• 40x 8.5 ltr pot
• 10 metres of 16mm pipe
• 20x AQUAvalve
• 10 metres of 6mm pipe
• 1x 16mm click-fit tank adapter and filter
• 40x marix disc
• 2x 16mm in-line tap
• 40x PotSock Square
Suggested layout
225 ltr
FlexiTank
400 ltr
FlexiTank
AQUAvalve
AQUAvalve
16mm click-fit tank adaptor & filter
16mm click-fit tank adaptor & filter
6mm pipe
6mm pipe
16mm pipe
16mm pipe
•
Pot up your plants, water through, then allow your plants to establish in the pots for a period of 7 to 10
days before turning your system on. This will encourage a stronger and healthier root system.
•
Always raise your tank to a minimum of 150mm above the highest AQUAvalve and re-fill the tank when
there is approximately a 1/3 of the solution left - NEVER ALLOW THE TANK TO RUN EMPTY.
•
For best results, we recommend mineral fertilisers. Do not use organic fertilisers, as they have a tendency
to block small pipe work.
•
Clean all substrate from the bottom and sides of the pots before placing in each tray.
This will ensure your system is clean from the start.
•
Always use free draining substrates, for example: soil/perlite, coco/perlite, soil/clay pebbles,
coco/clay pebbles, rockwool/clay pebbles.
[email protected] I www.autopot.co.uk I +44 (0)844 8581520
Plan views
and options
16mm tee connector
16mm – 6mm cross connector
16mm tee connector
16mm – 6mm cross connector
16mm in-line tap
16mm in-line tap
Advice
easy2grow dimensions
575mm
245mm
8.5 ltr
pot
195mm
1
Put black marix
discs in pots.
3
Remove collar.
Push 6mm pipe through
collar and attach to
AQUAvalve nozzle.
Rescrew collar - DON'T
overturn... when you
feel it grip STOP.
5
5
Fit PotSock Squares
over the bases
of the pots
7
According to the size of your system connect your
6mm/16mm pipe to relevant fitting or tank...
Using your front instruction sheet, repeat the module set up instructions for the number of trays.
Allow your plants to establish for 7-10 days before turning system on
Advice
If you require any guidance email - [email protected]
easy2grow 40
setup instructions
400 ltr
FlexiTank
680mm
2
Fill pots with medium
and pot up plants.
Water through pots
and allow to drain
outside the tray.
4
Connect AQUAvalve
so 'half moon' is on
T section in the tray.
Position tray
so it is level
6
Cut 6mm/16mm pipe
to appropriate length.
8
Place both pots in
tray, make sure they
are CLEAN!
Place lid over valve
onto tray.