Dynatech ASG Series Kullanım Kılavuzu - Sayfa 6

Endüstriyel Ekipmanlar Dynatech ASG Series için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Dynatech ASG Series 11 sayfaları.

INSTRUCTIONS: REPLACEMENT/SAFETY GEAR; Code: DYN 32.03.00

Date: 29/06/2016

Revision: 00

7. If the safety gear type has to be changed with the shoe, the fastener block must also be replaced for

the corresponding type, which is marked with a letter identifying it. There are two symmetrical parts

that are inserted as shown in Figure5. One part should be replaced first, followed by the other, so as

not to leave the block loose. This part is to adjust the distance between the shoe and the guide rail

centre. If they are not replaced, the distance between the guide rail centre and frame attachments

will not correspond to those in the safety gear (DYN 32) usage and maintenance instructions.

Figure5 Replacing the attachment block part and symmetrical block attachment

8. Place the identification sticker on the upper part, as shown in Figure1.

9. Explanatory video link (registered customers only):

http://customers.dynatech-elevation.com/download.php?file=imagenes/documentos/doc-00595.mp4

2.2 PR-2500 UD/ PQ-3400 UD/ PQ-4000 UD

There are two types of PR-2500 UD V50/ PQ-3400 UD/ PQ-4000 UD safety gear depending on the thickness

of the shoe assembled. The safety gear types refer to the guide rail centre position in relation to the frame

attachment holes, which are in accordance with the measurement recommended in the safety gear usage

and maintenance instructions. Thus, the gap between the shoe and guide rail established by Dynatech is

observed.

TYPE

THICKNESS (mm)

7-8-9-10

11-12-13-14-15-16