HighGear Loft Kullanıcı Kılavuzu - Sayfa 7

İzle HighGear Loft için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. HighGear Loft 19 sayfaları. Altiware series

Sayfayı Yazdır

KEYS AND THEIR FUNCTIONS

The Loft unit is equipped with 5 individual keys. Each key has several functions. The

drawing shows the keys and their names as used in this manual. To make it easy to

remember, some of the functions of the keys are also engraved on the bezel around the

lens of the watch.

S5 KEY

a. Enter/Exit Setting mode

for each function

b. Activate EL backlight

system

S4 KEY

a. Advances display

through the various

operational modes

b. Selects variable in

Setting modes

S3 KEY

a. Changes view in

Barometer, Altimeter and

Chronograph modes

ALTIWARE SERIES

S1 KEY

a. Changes view in Time, Barometer

and Altimeter modes

b. Stores memory information in

Altimeter mode

b. Advances variable in Setting

modes

c. Starts/Split action in Chronograph

mode

d. Turns Daily Alarms On/Off

S2 KEY

a. View/Select Time 1 or Time 2 in

Time of Day mode

b. View/Select C/F and inHg/mbar

in Barometer mode

c. View/Select Ft/M in Altimeter

mode

d. Reverses Variable in Setting

modes

e. Stop Chronograph

f. Select Alarm 1/2

PROGRAMMING THE WATCH

KEY PRESSES

There are two key actions used to program the watch

QUICK PRESS – The key is pressed quickly and immediately released. This is the most common key action and

is used for most aspects of the watches operation

PRESS & HOLD – The key is pressed and held for 2-3 seconds. This key action is generally used to initiate a

programming sequence or to change an on screen variable.

Generally, when a PRESS & HOLD action is required, the word HOLD will appear on the center line of the

display.

COMMON KEY ACTIONS

All functions of the watch are programmed in the same basic way. The only thing which changes are the variables being

programmed.

ENTER A PROGRAMMING SEQUENCE – PRESS & HOLD THE S5 KEY

The words ADJUST---HOLD will appear in the top and center lines of the display. Continue to hold the key

until the display automatically advances to the first variable in the programming sequence.

ADJUST A VARIABLE IN A PROGRAMMING SEQUENCE – QUICK PRESS THE S1 AND S2 KEYS

Variables in a programming sequence are adjusted up using a quick press of the S1 key and down using a quick

press of the S2 key.

ADVANCE TO NEXT VARIABLE IN A PROGRAMMING SEQUENCE – QUICK PRESS THE S4 KEY

When you have chosen the variable you want for a particular portion of a programming sequence QUICK PRESS

the S4 key to set and advance to the next variable

As long as you QUICK PRESS the S4 key, you will continue to cycle through the variables for that sequence.

EXIT A PROGRAMMING SEQUENCE – QUICK PRESS THE S5 KEY

Once all variables of a programming sequence have been entered to your satisfaction, QUICK PRESS the S5 key

to exit the programming sequence and return to the initial main display.

ILLUMINATE THE BACKLIGHT – QUICK PRESS THE S5 KEY

In normal operating modes, QUICK PRESS the S5 KEY to operate the display backlight.

Backlight will not function if you are in a PROGRAMMING SEQUENCE. To operate backlight, you must exit

programming sequence by QUICK PRESSING the S5 key.

LOFT