autoright 4 inch Cordless Manuel - Sayfa 8
Sander autoright 4 inch Cordless için çevrimiçi göz atın veya pdf Manuel indirin. autoright 4 inch Cordless 16 sayfaları. 12 volt, 4 inch cordless detailing polisher
Sayfayı YazdırBATTERY PACK INSTALLATION
1. Insert the BATTERY PACK into the polisher.
Align the polarity rib on the BATTERY PACK
with the polarity slot in the polisher handle
and slide the pack into the polisher. Make
sure the latches on the BATTERY PACK have
snapped into place.
2. Check the BATTERY PACK alignment by
lightly pulling on the end of battery pack.
POLISHING
1. Place proper pad according to Figure 1.
2. Hold in the MOTOR SWITCH; polish the
wax from front to back, side to side using
long strokes. Figure 2.
3. Remove the wax or polish in the same order
as it was applied.
4. DO NOT press down. Let the polisher do the
work. If the wax seems difficult to polish, you
may have applied too much wax.
CARE OF BONNET AND PADS
The application pads and polishing bonnets
are washable and re-usable. Hand washing
and air-drying is recommended for longer
bonnet life. However, the bonnets may be
machine-washed in cold water with a small
amount of detergent and machine dried at
medium heat.
• Always remove the bonnet from the pad
when the polisher is not in use. This will allow
the pad to dry out and retain its original
shape.
• To prolong pad life and shape, store polisher
with pad face up.
• Do not use abrasive compounds on the pad.
• Do not apply too much wax to the bonnet.
If the pad becomes saturated, the polisher
will not work as well and the pad will not last
as long. If polishing seems difficult too much
wax may have been applied.
OPERATING INSTRUCTIONS
4 INcH cOrdLESS
Figure 1
Figure 2
POLISHER MAINTENANCE/STORAGE
Use mild soap and damp sponge to clean
the polisher.
The battery pack of the polisher shall be
charged frequently to extend the life of
the battery.
When storing the polisher, do not store with
bonnet on pad. Disconnect battery pack prior
to unit storage.
ENGLISH
8