Gallagher TWR-5 Hızlı Başlangıç Kılavuzu - Sayfa 8
Terazi Gallagher TWR-5 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Gallagher TWR-5 16 sayfaları. Weigh scale unit
Ayrıca Gallagher TWR-5 için: Hızlı Başlangıç Kılavuzu (16 sayfalar)
Sayfayı Yazdır
CONNECTING EQUIPMENT TO THE TWR-1
Connecting an EID Reader
•
The TWR-1 internal reader can be used with or without loadbars connected.
To use the internal reader, you must first connect the antenna panel. Refer to
Attaching the TWR-1 to the Antenna panel (p. 6)
•
A Hand-held EID Reader or permanent reader can be connected to the TWR-1
by either a serial cable or via Bluetooth®.
1.
If using a hand-held reader or permanent reader, turn On the EID Reader.
2.
For all readers, turn On the TWR-1.
3.
On the TWR-1, tap
4.
Select how the Reader is being connected. This will be by Bluetooth, Serial
cable or using the internal reader (Panel).
If using the internal reader, a successful connection will show as
footer bar.
Note: A mini serial adapter is included with the TWR-1 if a female serial
connection is required.
Important: The TWR-1 can also be connected to via Bluetooth as a "Slave",
by initiating the connection from the reader. A pass-code of "0000" may be
required to complete this connection.
Refer to Bluetooth – Connect EID Reader in the TWR-1 On-screen Help or your EID
Reader User Manual for further information on pairing the reader.
Connecting to a Drafter/Sorter
To connect the TWR-1 to a drafter, use the data cables supplied with your drafter.
Refer to your Drafter User Manual for more information.
1.
Turn On the TWR-1.
2.
On the TWR-1, tap
3.
Specify the type of drafter that is being connected, to complete the setup.
If your drafter is not listed, tap
wizard set up your drafter.
8
Gallagher TWR-1 Weigh Scale Quick Start Guide
Settings
> Equipment Connections > EID Reader
Settings
> Equipment Connections > Drafter
Create Custom
and follow the configuration
.
in the
.