DCS CT-365BK Kullanım ve Bakım Kılavuzu - Sayfa 10

Havalandırma Davlumbazı DCS CT-365BK için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. DCS CT-365BK 18 sayfaları. Professional 5 burner 36” drop-in cooktop
Ayrıca DCS CT-365BK için: Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (15 sayfalar)

Sayfayı Yazdır

CARE AND MAINTENANCE

CLEANING THE BURNERS:

For proper Highting and performance,

keep the

burners dean and dry. Ht is necessary to dean

the burners

if they do not Hight aHthough the

igniter chicks, whenever there has been a severe

boll over or when the flame doesn't burn bHue.

Be certain a[[ burner knobs are in the OFF

position

before

attempting

to dean

the

burners. The burners have been designed for

ease of cHeaning.When the grates and burners

are cooH,remove the grate.The Burner Cap and

the Brass Port Ring can easily be lifted off.Wash

these parts in hot soapy water, rinse and dry

thoroughHy. The Burner Caps are porceHain

enameH,follow the directions on page 8 that

were given to dean the burner grates.A bristle

brush can be used to dean out the toothed

burner ports, if necessary. DisassembHyof the

Brass Port

Ring

Locating

Brass

Port Ring

Hex Nut

Locating

Pin HoHe

Hnside

Base

Simmer Ring is not recommended,

however, it may become

necessary to do so if the ports remain

dogged

after normaH cHea ning. ff it is necessary to disassembHe the Simmer Ring from the Base, remove

the Hex Nut at the top of the Simmer Ring.CHean the Simmer Ring with hot soapy water using a soft

wire or pHastic bdstHe brush then dry thoroughHy. Re-assembHe the parts using the Hex Nut.

After cleaning, it is important

to make sure the Locating Pin on the bottom

side of the Simmer Ring is

properHy aHigned with the corresponding

homein the Base and that the Locating

Pin (see above) in the

bottom

side of the Brass Port Ring is properHy aHigned with the Locating

Notch on the top side of the

Simmer

Ring. Hncorrect aHignment will[ produce

a potentiaHHy dangerous

flame

and

poor burner

performance.

See the iHHustration above.

CLEANING THE IGNITERS:

Be certain aHH burner knobs are in the OFF

position

before attempting

to dean the igniters. GentHy

wipe with an aHcohoHdampened

cotton

swab and be carefuH not to damage the igniter.

IGNITER