DCS RGSC-305SS Kurulum Kılavuzu - Sayfa 12
Menziller DCS RGSC-305SS için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. DCS RGSC-305SS 17 sayfaları. Professional 30” self clean gas range
Sayfayı Yazdır
ANTI-TIP DEVICE INSTALLATION INSTRUCTIONS
STEP 7: ANTI-TIP DEVICE INSTALLATION
All ranges must have an anti-tip device correctly installed as per these instructions. If you pull the
range out from the wall for any reason, make sure that the device is properly engaged when you
push the range back against the wall. If it is not, there is a possible risk of the range tipping over
and causing injury if you or a child stand, sit or lean on an open door.
INCLUDED PARTS:
Included with this kit are:
(4) #10 x 2" wood screws,
(1) Anti-tip bracket, and (1)
Installation Instructions.
INSTALLING THE KIT:
Instructions are provided
for wood and cement
floors. Any other type or
construction may require
special
installation
techniques
as
deemed
necessary
to
provide
adequate fastening of the
Anti-tip bracket to the floor
and wall. The use of this
bracket does not preclude
tipping of the range when
not properly installed.
WOOD
CONSTRUCTION:
Place the bracket against
the back wall, into the right rear corner where the range is to be located. Leave a gap between the wall
(or side of range) and the bracket of 3/4" . Drill (2) 1/8" diameter pilot holes in the center of the small
holes. A mail or awl may be used if a drill is not available. Fasten the bracket securely to the floor and
wall. See Fig. 13.
CONCRETE OR CEMENT CONSTRUCTION:
HARDWARE REQUIRED: (2) sleeve anchors, lag bolts,
and washers (not provided). Locate the bracket as
described above. Drill the recommended size holes
for the hardware. Install the sleeve anchors into the
holes and then install the lag bolts through the
bracket. The bolts must be properly tightened as
recommended for the hardware. Fasten the bracket
securely to the floor and wall.
ONCE INSTALLED:
Complete the range installation per the instructions provided with the product. Check for proper
installation of the Range and Anti-tip device by grasping the back of the unit and carefully attempt to
tilt the range forward.
(2)Small Holes for
Wood Installations
(2) Large Holes for
Concrete Installations
3/4"
11
(2) Wood Screws
into Back Wall (ALL
Installations)
FIG. 13
WARNING
ALL RANGES CAN TIP
INJURY COULD RESULT
INSTALL ANTI-TIP
BRACKET PACKED
INSIDE OVEN
SEE INSTRUCTIONS
BACK
WALL