Dynaudio Xeo 10 Kullanıcı El Kitabı - Sayfa 16

Konuşmacılar Dynaudio Xeo 10 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Dynaudio Xeo 10 18 sayfaları.

Sayfayı Yazdır

Dynaudio Xeo 10/20/30

Declaration of Conformity (EU only)

Dynaudio A/S hereby declares, that the product Dynaudio Xeo 10 / Xeo 20 / Xeo 30 is in

conformity with the following directives:

• 2001/95/EF (Product Safety)

• 2014/53/EU (RE directive)

• 2014/30/EU (EMC directive)

• 2011/65/EU (ROHS directive)

• 1275/2008 (ErP, Ecodesign directive)

The Declaration of Conformity is available on the Internet at dynaudio.com/

support/manuals

Reminding (USA and Canada only)

A polarized plug has two blades with

(1) cet appareil ne doit pas provoquer

one wider than the other. A grounding

d'interférences néfastes, et (2) cet

type plug has two blades and a third

appareil doit tolérer les interférences

grounding prong. The wide blade or the

reçues, y compris celles qui risquent

third prong are provided for your safety.

de provoquer un fonctionnement

If the provided plug does not fit into

indésirable.

your outlet, consult an electrician for

replacement of the obsolete outlet.

Note: This product has been tested

and found to comply with the limits for

This device complies with Part 15 of the

a Class B digital device, pursuant to

FCC Rules. Operation is subject to the

Part 15 of the FCC Rules. These limits

following two conditions: (1) This device

are designed to provide reasonable

may not cause harmful interference,

protection against harmful interference

and (2) This device must accept

in a residential installation. This product

any interference received, including

generates, uses, and can radiate radio

interference that may cause undesired

frequency energy and, if not installed and

operation.

used in accordance with the instructions,

may cause harmful interference to radio

Cet appareil est conforme à Ia section

communications. However, there is no

15 des réglementations de Ia FCC.

guarantee that interference will not occur

Le fonctionnement de l'appareil est

in a particular installation. If this product

sujet aux deux conditions suivantes:

does cause harmful interference to radio

or television reception, which can be

determined by turning the equipment off

and on, the user is encouraged to try to

correct the interference by one or more

of the following measures:

• Reorient or relocate the receiving

antenna.

• Increase the separation between the

equipment and receiver.

• Connect the equipment into an outlet

on a circuit different from that to

which the receiver is connected.

• Consult the dealer or an experienced

radio/TV technician for help.

Please take attention that changes or

modification not expressly approved by

the party responsible for compliance

could void the user's authority to operate

the equipment.

This equipment should be installed and

operated with a minimum distance 20 cm

between the radiator and your body.

IC NOTICE

This device complies with Industry

Conformément à la réglementation

Canada licence-exempt RSS standard(s).

d'Industrie Canada, le présent émetteur

Operation is subject to the following

radio peut

two conditions: (1) this device may not

fonctionner avec une antenne d'un

cause interference, and (2) this device

type et d'un gain maximal (ou inférieur)

approuvé pour l'émetteur par Industrie

must accept any interference, including

interference that may cause undesired

Canada. Dans le but de réduire les

operation of the device.

risques de brouillage radioélectrique à

l'intention des autres utilisateurs, il faut

Le présent appareil est conforme aux

choisir le type d'antenne et son gain de

CNR d'Industrie Canada applicables

sorte que la puissance isotrope rayonnée

aux appareils radioexempts de licence.

équivalente (p.i.r.e.) ne dépasse pas

L'exploitation est autorisée aux deux

l'intensité nécessaire à l'établissement

conditions suivantes : (1) l'appareil ne

d'une communication satisfaisante.

doit pas produire de brouillage, et (2)

l'utilisateur de l'appareil doit accepter

MPE Reminding

tout brouillage radioélectrique subi,

(i) The device for operation in the band

même si le brouillage est susceptible

5150 – 5250 MHz is only for indoor

d'en compromettre le fonctionnement.

use to reduce the potential for harmful

interference to co-channel mobile

Under Industry Canada regulations, this

satellite systems;

radio transmitter may only operate using

(ii) The maximum antenna gain

an antenna of a type and maximum (or

permitted for devices in the bands

lesser) gain approved for the transmitter

5250 – 5350 MHz and 5470 – 5725 MHz

by Industry Canada. To reduce potential

shall comply with the e.i.r.p. limit; and

radio interference to other users, the

(ii1) The maximum antenna gain

antenna type and its gain should be so

permitted for devices in the band

chosen that the equivalent isotropically

5725 – 5825 MHz shall comply with the

radiated power (e.i.r.p.) is not more

e.i.r.p. limits specified for point-to-point

than that necessary for successful

and non point-to-point operation as

communication.

appropriate.

Connection options

Cet équipement doit être installe et

utilisé à une distance minimale de 20 cm

entre le radiateur et votre corps.

(i) Tout appareil destiné à la bande

5150 – 5250 MHz devra être

exclusivement utilisé en intérieur a fin

de réduire les risques de perturbations

électromagnétiques gênantes sur les

systèmes de satellite mobile dans un

même canal.

(ii) Les radars à forte puissance sont

désignés comme les utilisateurs

principaux (c'est-à-dire qu'ils

sont prioritaires) des bandes

5250 – 5350 MHz et

(iii) 5650 – 5850 MHz. IIs peuvent

provoquer des perturbations

électromagnétiques sur les appareils de

type LELAN (réseau de communication

local sans licence) ou les endommager.