Dynaudio 18S Talimatlar Kılavuzu - Sayfa 13
Subwoofer Dynaudio 18S için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Dynaudio 18S 15 sayfaları. Active dsp subwoofer
Sayfayı Yazdır
The 18S configuration menu parameters
•
Presets: The 18S incorporates low
and their options are described in the
pass filter presets to match a range
following paragraphs:
of Dynaudio speaker models. If
your 18S is to be used in a system
•
Input sensitivity: Adjusts the input
with one of the Dynaudio models
sensitivity to match the output level
listed, select it to configure the 18S
of your pre-amplifier or audio-
low pass filter appropriately. If your
visual processor. Initially select the
subwoofer is to be used for the LFE
0dB option. Only adjust the input
channel in a home theatre system
sensitivity if the subwoofer volume
select the filter Bypass option.
adjustment doesn't provide a
suitable range.
•
Parametric EQ: Provides three
bands of low frequency parametric
•
Volume: Set to match the volume of
equalisation. Each band offers
your main speakers so that bass at
frequency, gain and Q parameters.
your main listening position is neither
Parametric is best used in
too prominent or too quiet.
combination with low frequency
room acoustic analysis to identify
frequency response anomalies. The
Note
equalisation is set to "flat" by default.
Setting the subwoofer volume is
important in terms of both overall
system balance and the demands
of different types of programme
Note
material.
If your Dynaudio speaker model
is not listed among the 18S
presets, or your 18S is to be
used with speakers from an
alternative manufacturer, select
the generic filter preset closest to
the speaker's specified -6dB low
frequency cut-off.
24
•
Auto standby: Select to specify
the delay time before the subwoofer
will switch to Standby mode when
unused. The auto standby feature
can also be switched off.
•
Line Wake-up: Select to enable or
disable trigger input switch on.
•
Left main speaker distance:
Select to specify the distance in
metres of the left channel monitor
from the listening position.
•
Right main speaker distance:
Select to specify the distance in
metres of the right channel monitor
from the listening position.
Subwoofer controls
•
Sub speaker distance: Select to
specify the distance in metres of
the subwoofer from the listening
position.
•
Status: Select to display the
subwoofer operational status.
•
Factory Reset: Select to return
your 18S to its default settings.
The rear panel Auto ON/OFF switch will
engage or defeat automatic switch on
and off in response to the presence or
absence of an input signal.
Control and configuration
Rotary controller:
Rotate to select.
Press to confirm.
25